74CBTLV3253 Datasheet PDF (Dual 1-of-4 multiplexer/demultiplexer)

74CBTLV3253 - Dual 1-of-4 multiplexer/demultiplexer

Description

The 74CBTLV3253 provides a dual 1-of-4 high-speed multiplexer/demultiplexer with two common select inputs (S0, S1) and two output enable inputs (1OE, 2OE).

Features

Supply voltage range from 2.3 V to 3.6 V.
High noise immunity.
Complies with JEDEC standard:.
JESD8-5 (2.3 V to 2.7 V).
JESD8-B/JESD36 (2.7 V to 3.6 V).
5 Ω switch connection between two ports.
Rail to rail switching on data I/O ports.
CMOS low power consumption.
Latch-up performance exceeds 250 mA per JESD78B Class I level A.
IOFF circuitry provides partial Power-down mode operation.
ESD protecti.

Datasheet Details

Part number	74CBTLV3253
Manufacturer	nexperia
File Size	331.89 KB
Description	Dual 1-of-4 multiplexer/demultiplexer
Datasheet	74CBTLV3253 Datasheet
Additional preview pages of the 74CBTLV3253 datasheet.

📁 Similar Datasheet

74CBTLV3253 - LOW-VOLTAGE DUAL 1-OF-4 MULTIPLEXER/DEMULTIPLEXER (Renesas)

74CBTLV3257 - Quad 1-of-2 multiplexer/demultiplexer (NXP)

74CBTLV3257 - LOW-VOLTAGE QUAD 2:1MUX/DEMUX BUS SWITCH (Renesas)

74CBTLV3244 - LOW-VOLTAGE OCTAL BUS SWITCH (Renesas)

74CBTLV3244 - LOW-VOLTAGE OCTAL BUS SWITCH (IDT)

74CBTLV3245 - 8-bit bus (NXP)

74CBTLV3245 - LOW-VOLTAGE OCTAL BUS SWITCH (Renesas)

74CBTLV3125 - 4-bit bus switch (NXP)

74CBTLV3126 - 4-bit Bus Switch (NXP)

74CBTLV3384 - LOW-VOLTAGE 10-BIT BUS SWITCH (Renesas)

Full PDF Text Transcription

Click to expand full text

74CBTLV3253 Dual 1-of-4 multiplexer/demultiplexer Rev. 7 — 23 April 2024 Product data sheet 1. General description The 74CBTLV3253 provides a dual 1-of-4 high-speed multiplexer/demultiplexer with two common select inputs (S0, S1) and two output enable inputs (1OE, 2OE). The low ON resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. When pin nOE = LOW, one of the four switches is selected (low-impedance ON-state) with pins S0 and S1. When pin nOE = HIGH, all switches are in the high-impedance OFF-state, independent of pins S0 and S1. To ensure the high-impedance OFF-state during power-up or power-down, nOE should be tied to the VCC through a pull-up resistor.

Published: Jul 24, 2019 |