Datasheet4U Logo Datasheet4U.com

HIP9020 - Programmable Quad Buffer with Pre and Post Scaler Dividers

Description

The HIP9020 is a Vehicle Speed Sensor (VSS) Buffer IC.

It receives sinusoidal vehicle speed information from a speedometer signal source.

The signal is amplified and squared before frequency processing is done.

Features

  • Sine Wave Speedometer Input.
  • Input Limiting.
  • . ±0.25V to ±100V (with 40kΩ).
  • Over Voltage Protection.
  • Current Limiting.
  • Programmable Prescaler 1, 6 - 11.
  • Post Scaler Frequency Divide by 1 or 2.
  • Drivers with 15mA/24V Capability.
  • Outputs 4 Separate Square Waves.
  • Internal Regulator and Bias Source.
  • 0kHz to 6kHz Input Signal Range.
  • -40oC to +125oC Operating Temperature Range Applicati.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HIP9010 Engine Knock Signal Processor Renesas
HIP9011 Engine Knock Signal Processor Renesas
HIP0045 1A/50V Octal Low Side Power Driver Renesas
HIP0050 0.3A/50V Octal Low Side Power Driver Renesas
HIP0051 0.25A/50V Octal Low Side Power Driver Renesas

Other Datasheets by Intersil (Renesas)

Part Number Description
HIP9021 Portable Battery Drive/Torque Controller for N-Channel MOSFETs in Motor Control Systems
HIP9022 Dual High Speed Laser Driver
HIP0063 Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control
HIP1030 1A High Side Driver with Overload Protection
HIP1031 Half Amp High Side Driver with Overload Protection

Full PDF Text Transcription

Click to expand full text
HIP9020 October 1993 Programmable Quad Buffer with Pre and Post Scaler Dividers Description The HIP9020 is a Vehicle Speed Sensor (VSS) Buffer IC. It receives sinusoidal vehicle speed information from a speedometer signal source. The signal is amplified and squared before frequency processing is done. The circuit provides pin programmable integer prescaler and postscaler dividers to scale the output frequencies. The prescaler divider output of the frequency doubler is mode selected for 1 and 6 through 11. The postscaler mode is selected to the Output 3 with a divide by 1 or 2. The four VOX outputs are open collector drivers.
Published: |