Datasheet4U Logo Datasheet4U.com

HIP1016 - Power Distribution Controller

Download the HIP1016 datasheet PDF. This datasheet also covers the HIP1015 variant, as both devices belong to the same power distribution controller family and are provided as variant models within a single manufacturer datasheet.

Description

Connect to the low side of the current sense resistor through the current limiting set resistor.

This pin functions as the current limit programming pin.

Features

  • HOT SWAP Single Power Distribution Control (HIP1015 for 12V, HIP1016 for 5V and Low Side Switch).
  • Undervoltage Monitoring and Notification.
  • Overcurrent Fault Isolation.
  • Programmable Current Regulation Level.
  • Programmable Current Limit Time to Latch-Off.
  • Rail to Rail Common Mode Input Voltage Range (HIP1015).
  • Internal Charge Pump Allows the use of N-channel MOSFET (HIP1015).
  • Undervoltage and Overcurrent Latch Indicators.

📥 Download Datasheet

Note: The manufacturer provides a single datasheet file (HIP1015-Renesas.pdf) that lists specifications for multiple related part numbers.

Datasheet Details

Part number HIP1016
Manufacturer Renesas
File Size 577.55 KB
Description Power Distribution Controller
Datasheet download datasheet HIP1016 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HIP1030 1A High Side Driver with Overload Protection Intersil Corporation
HIP1031 Half Amp High Side Driver with Overload Protection Intersil Corporation
HIP1090 Protected High Side Power Switch with Transient Suppression Intersil Corporation
HIP0063 Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control Intersil Corporation
HIP2106 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver Intersil Corporation

Other Datasheets by Renesas

Part Number Description
HIP1011 PCI Hot Plug Controller
HIP1011A PCI Hot Plug Controller
HIP1011B PCI Hot Plug Controller
HIP1011D Dual Slot PCI Hot Plug Controller
HIP1011E Dual Slot PCI Hot Plug Controller

Full PDF Text Transcription

Click to expand full text
HIP1015, HIP1016 Power Distribution Controllers The HIP1015 and HIP1016 are hot swap power controllers. The HIP1015 is targeted for a +12V bus whereas the HIP1016 is targeted for +5V applications. Each has an undervoltage (UV) monitoring and reporting with a threshold level ~17% lower than the nominal +12V and +5V. The HIP1015 has an integrated charge pump allowing control of up to a +12V bus using an external N-channel MOSFET. The HIP1016 can also be used to control much higher positive or negative voltages in a low side controller configuration. Both the HIP1015 and HIP1016 feature programmable Overcurrent (OC) detection, current limiting regulation with time delay to latch off and soft start. Ordering Information TEMP.
Published: |