Datasheet4U Logo Datasheet4U.com

CLC5506 - Gain Trim Amplifier (GTA)

Description

The CLC5506 is a low-noise amplifier with programmable gain for use in cellular base stations, WLL, radar and RF/IF subsystems where gain-control is required to increase the dynamic range.

Features

  • n n n n n n n n n n n n 600MHz bandwidth 26dB maximum gain @ 150MHz 16dB gain control range Attenuation step size: 0.25dB 4.8dB noise figure @ 26dB +22dBm output IP3 @ 18dB gain Digital ″dB Linear″ gain control Supply voltage: 5V Supply current: 75mA Supply shutdown: 35µA Package: SOIC-14 Typical at 25˚C.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
CLC-207 Low Distortion Wideband Op Amp Comlinear Corporation
CLC001 CLC001 Serial Digital Cable Driver with Adjustable Outputs (Rev. B) ETCTI
CLC006 CLC006 Serial Digital Cable Driver with Adjustable Outputs (Rev. G) ETCTI
CLC007 CLC007 Serial Digital Cable Driver with Dual Complementary Outputs (Rev. E) ETCTI
CLC020 CLC020 SMPTE 259M Digital Video Serializer with Integrated Cable Driver (Rev. E) ETCTI

Other Datasheets by National Semiconductor (Texas Instruments)

Part Number Description
CLC5509 Ultra-Low Noise Preamplifier
CLC5523 Low-Power/ Variable Gain Amplifier
CLC5526 Digital Variable Gain Amplifier (DVGA)
CLC501 High-Speed Output Clamping Op Amp
CLC502 Clamping/ Low-Gain Op Amp with Fast 14-bit Settling

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
CLC5506Gain Trim Amplifier (GTA) September 1999 CLC5506 Gain Trim Amplifier (GTA) General Description The CLC5506 is a low-noise amplifier with programmable gain for use in cellular base stations, WLL, radar and RF/IF subsystems where gain-control is required to increase the dynamic range. The CLC5506 allows designers to compensate for manufacturing component tolerances and temperature variations in receiver front ends. Maximum amplifier gain is set at 26dB . A three-line MICROWIRE serial interface allows 16dB of attenuation from the max gain setting in precise 0.25dB steps. The CLC5506 uses a differential input and output, allowing large output swings on a single 5V rail.
Published: |