Datasheet4U Logo Datasheet4U.com

HIP7020 - J1850 Bus Transceiver For Multiplex Wiring Systems

Description

The HIP7020 IC is an Integrated I/O Bus Transceiver designed for the SAE Standard J1850 Class B Data Communication Network Interface.

The Bus transmits and receives data on a single wire using a 10.4kHz VPWM (Variable Pulse Width Modulated) signal.

Features

  • J1850 Bus Transceiver for MX Wiring.
  • 5V CMOS/TTL Logic Interface.
  • Current Controlled Transmitter Driver.
  • Controlled Rise/Fall Time of Bus Drive for Both Voltage and Current.
  • Bus Drive Capability to Less Than 500Ω with a 5µs Load RC Time Constant.
  • Filtered Bus Input Receiver.
  • Ground Fault Tolerant for Bus Isolation.
  • Short Circuit and Over Temperature Protection.
  • Protection for Reverse Battery, Load Dump and Latch-Up.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HIP0045 1A/50V Octal Low Side Power Driver Renesas
HIP0050 0.3A/50V Octal Low Side Power Driver Renesas
HIP0051 0.25A/50V Octal Low Side Power Driver Renesas
HIP0060 50V Quad Low Side Power Driver Renesas
HIP0061 3-Transistor Common Source ESD Protected Power MOSFET Array Renesas

Other Datasheets by Intersil (Renesas)

Part Number Description
HIP7010 J1850 Byte Level Interface Circuit
HIP7030A0 J1850 8-Bit 68HC05 Microcontroller Emulator Version
HIP7030A2 J1850 8-Bit 68HC05 Microcontroller
HIP7038A8 J1850 8-Bit 68HC05 Microcontroller 8K EEPROM Version
HIP0063 Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
HIP7020 June 1998 J1850 Bus Transceiver For Multiplex Wiring Systems Description The HIP7020 IC is an Integrated I/O Bus Transceiver designed for the SAE Standard J1850 Class B Data Communication Network Interface. The Bus transmits and receives data on a single wire using a 10.4kHz VPWM (Variable Pulse Width Modulated) signal. The HIP7020 serves as an I/O buffer interfacing to 5V CMOS logic. It is designed to operate directly from the 12V battery line of an automobile. The normal Bus voltage swing capability is from 0V to 7.75V at currents greater than 20mA. As shown in the Block Diagram, the Transmitter TX Input and the Receiver RX Output of the Bus Transceiver Circuit interface to the control logic.