Datasheet4U Logo Datasheet4U.com

CXA2513M - 3-Band Preset Graphic Equalizer IC (with standby and memory on last preset mode)

Description

The CXA2513M is a 3-band preset graphic equalizer developed for stereo set, cassette tape recorder with radio, etc.

It has 5 modes: FLAT, ROCK, VOCAL, POP and JAZZ.

The selection is via 5 control pins.

Features

  • Very few external parts.
  • 3-band monolithic filters (100Hz, 1kHz, 10kHz).
  • The center frequencies of the band-pass filters can be adjusted.
  • 5 preset modes (FLAT, ROCK, VOCAL, POP, JAZZ).
  • Equips with output ports to drive external LEDs.
  • Mute pulse output pin.
  • Standby feature with last preset mode memory.
  • Can be initialized to one of the two preset modes (FLAT or ROCK).

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
CXA2520 LED Cree
CXA2521AQ RF AMplifier for CD Player and CD-ROM Sony
CXA2521Q RF AMplifier for CD Player Sony
CXA2530 LED Cree
CXA2540 LED CREE

Other Datasheets by Sony Semiconductor Solutions

Part Number Description
CXA2510AQ Dolby B Type Noise Reduction System with Playback Equalizer Amplifier
CXA2511AQ Dolby B-C Type Noise Reduction System with Playback Equalizer Amplifier
CXA2515AM RF Amplifier for CD Player and CD-ROM
CXA2515AN RF Amplifier for CD Player and CD-ROM
CXA2500M Dual REC/PB Preamplifier

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
CXA2513M 3-Band Preset Graphic Equalizer IC (with standby and memory on last preset mode) Description The CXA2513M is a 3-band preset graphic equalizer developed for stereo set, cassette tape recorder with radio, etc. It has 5 modes: FLAT, ROCK, VOCAL, POP and JAZZ. The selection is via 5 control pins. The center frequencies of three bands are 100Hz, 1kHz and 10kHz. The center frequencies of these bands are determined by 2 external resistors. It also has a standby feature. When the standby pin goes low, the IC stores the last preset mode. When this pin goes high, the IC restores the last preset mode before standby. It can be initialized to any one of the two preset modes (FLAT, ROCK) upon power up.
Published: |