X9C503 Datasheet PDF (Digitally Controlled Potentiometer)

X9C503 - Digitally Controlled Potentiometer

Download the X9C503 datasheet PDF (X9C102 included). The manufacturer datasheet provides complete specifications, pinout details, electrical characteristics, and typical applications for digitally controlled potentiometer.

Description

INCREMENT The INC input is negative-edge triggered.

Toggling INC will move the wiper and either increment or decrement the counter in the direction indicated by the logic level on the U/D input.

Features

Solid-State Potentiometer.
Three-Wire Serial Interface.
100 Wiper Tap Points - Wiper Position Stored in Non-volatile Memory and Recalled on Power-up.
99 Resistive Elements - Temperature Compensated - End-to-End Resistance, ±20% - Terminal Voltages, ±5V.
Low Power CMOS - VCC = 5V - Active Current, 3mA max. - Standby Current, 750µA max.
High Reliability - Endurance, 100,000 Data Changes per Bit - Register Data Retention, 100 years.
X.

📥 Download Datasheet

X9C503 digitally controlled potentiometer by Renesas - Datasheet Preview — Note: The manufacturer provides a single datasheet file (X9C102-Renesas.pdf) that lists specifications for multiple related part numbers.

Datasheet Details

Part number	X9C503
Manufacturer	Renesas
File Size	614.88 KB
Description	Digitally Controlled Potentiometer
Datasheet	X9C503 Datasheet

📁 Similar Datasheet

X9C503 - Digitally Controlled Potentiometer (Intersil)

X9C102 - Digitally Controlled Potentiometer (Intersil)

X9C103 - Digitally Controlled Potentiometer (Intersil)

X9C104 - Digitally Controlled Potentiometer (Intersil)

X9C303 - Digitally Controlled Potentiometer (Xicor)

X9C303 - Logarithmic Digitally Controlled Potentiometer (Intersil Corporation)

Full PDF Text Transcription

Click to expand full text

DATASHEET X9C102, X9C103, X9C104, X9C503 Digitally Controlled Potentiometer (XDCP™) The X9C102, X9C103, X9C104, X9C503 are digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by a three-wire interface. The potentiometer is implemented by a resistor array composed of 99 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up operation.

Published: Jan 28, 2019 |