DESCRIPTION Controls the direction of wiper movement and whether the counter is incremented or decremented Negative bias voltage for the potentiometer wiper control Ground Chip select.
Key Features
Non-Volatile Solid-State Potentiometer.
Up/Down Interface with Chip Select Enable.
DCP Terminal Voltage ±2.7V to ±5.5V.
128 Wiper Tap Points - Wiper position stored in nonvolatile memory and recalled on power-up.
127 Resistive Elements - Typical RTOTAL tempco = ±50ppm/°C - End to end resistance range ±20%.
Low Power CMOS - Standby current, 1µA - Active current, 3mA max - VCC = 2.7V to 5.5V - V- = -2.7V to -5.5V.
Full PDF Text Transcription for ISL95710 (Reference)
Note: Below is a high-fidelity text extraction (approx. 800 characters) for
ISL95710. For precise diagrams, and layout, please refer to the original PDF.
ISL95710 NOTRREECCOOMMMMEENNDDEEDDRFEOPRLANCEEWMDEENST:IGNS ISL95310 Digitally Controlled Potentiometer (XDCP™), Terminal Voltage ±2.7V to ±5V, 128 Taps, Up/Down Interfac...
View more extracted text
ter (XDCP™), Terminal Voltage ±2.7V to ±5V, 128 Taps, Up/Down Interface DATASHEET FN8240 Rev 3.00 August 31, 2006 The Intersil ISL95710 is a digitally controlled potentiometer (XDCP). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The wiper position is controlled by a Up/Down interface. The potentiometer is implemented by a resistor array composed of 127 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs.
ISL95710 Datasheet
