Datasheet4U Logo Datasheet4U.com

33886 - 5.0A H-Bridge

General Description

of each pin can be found in the Functional Pin Description section beginning on page 16.

Definition Low-current analog signal ground.

Fault Status for H- Open drain active Low Fault Status output requiring a pull-up resistor to 5.0 V.

Key Features

  • 5.0 V to 40 V continuous operation.
  • 120 m RDS(on) H-Bridge MOSFETs.
  • TTL /CMOS compatible Inputs.
  • PWM frequencies up to 10 kHz.
  • Active current limiting via internal constant off-time PWM (with temperature-dependent threshold reduction).
  • Output short-circuit protection.
  • Undervoltage shutdown.
  • Fault status reporting VW SUFFIX (PB-FREE) 98ASH70702A 20-PIN HSOP.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
33887 5.0A H-Bridge with Load Current Feedback NXP
33887 5.0 A H-Bridge with Load Current Feedback Motorola Inc
33888 Quad High-Side and Octal Low-Side Switch for Automotive Motorola Inc
33888A Quad High-Side and Octal Low-Side Switch for Automotive Motorola Inc
33889 System basis chip NXP

Other Datasheets by Freescale Semiconductor (now NXP Semiconductors)

Part Number Description
33880 Configurable Octal Serial Switch
33882 Six-Output Low-Side Switch
33883 H-Bridge Gate Driver IC
33884 Switch Monitor Interface
33889 System Basis Chip

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Freescale Semiconductor Technical Data Document Number: MC33886 Rev 10.0, 01/2014 5.0 A H-Bridge The 33886 is a monolithic H-Bridge ideal for fractional horsepower DC-motor and bi-directional thrust solenoid control. The IC incorporates internal control logic, charge pump, gate drive, and low RDS(ON) MOSFET output circuitry. The 33886 is able to control continuous inductive DC load currents up to 5.0 A. Output loads can be pulse width modulated (PWM-ed) at frequencies up to 10 kHz. A Fault Status output reports undervoltage, short-circuit, and overtemperature conditions. Two independent inputs control the two half-bridge totem-pole outputs. Two disable inputs force the H-Bridge outputs to tri-state (exhibit high-impedance).