Datasheet4U Logo Datasheet4U.com

33882 - Six-Output Low-Side Switch

General Description

1 6 18 VPWR Load Supply Voltage This pin is connected to battery voltage.

A decoupling cap is required from VPWR to ground.

Key Features

  • including low standby current, fault status reporting, internal 52 V clamp on each output, output specific diagnostics, and protective shutdown. Additionally, it has a mode select pin affording a dual means of input control. Features.
  • Outputs clamped for switching inductive loads.
  • Very low operational bias currents (< 2.0 mA).
  • CMOS input logic compatible with 5.0 V logic levels.
  • Robust load dump (60 V transient at VPWR on OUT0.
  • OUT5).
  • Daisy ch.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
33887 5.0A H-Bridge with Load Current Feedback NXP
33887 5.0 A H-Bridge with Load Current Feedback Motorola Inc
33888 Quad High-Side and Octal Low-Side Switch for Automotive Motorola Inc
33888A Quad High-Side and Octal Low-Side Switch for Automotive Motorola Inc
33889 System basis chip NXP

Other Datasheets by Freescale Semiconductor (now NXP Semiconductors)

Part Number Description
33880 Configurable Octal Serial Switch
33883 H-Bridge Gate Driver IC
33884 Switch Monitor Interface
33886 5.0A H-Bridge
33889 System Basis Chip

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Freescale Semiconductor Technical Data Six Output Low-side Switch with SPI and Parallel Input Control Document Number: MC33882 Rev. 11.0, 11/2014 33882 The 33882 is a smart 6 output low-side switch able to control system loads up to 1.0 A. The six outputs can be controlled via both serial peripheral interface (SPI) and parallel input control, making the device attractive for fault tolerant system applications. There are two additional 30 mA low-side switches with SPI diagnostic reporting (parallel input control only). The 33882 is designed to interface directly with industry standard microcontrollers via SPI to control both inductive and incandescent loads. Outputs are configured as open drain power MOSFETs incorporating internal dynamic clamping and current limiting.