Datasheet4U Logo Datasheet4U.com

74ALVCH162244 - 16-bit buffer/line driver

General Description

The 74ALVCH162244 is a 16-bit non-inverting buffer/line driver with 3-state outputs.

The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer.

The 3-state outputs are controlled by the output enable inputs 1OE, 2OE, 3OE and 4OE.

Key Features

  • Wide supply voltage range from 1.2 V to 3.6 V.
  • CMOS low power consumption.
  • MultiByte flow-through standard pin-out architecture.
  • Low inductance multiple VCC and GND pins for minimum noise and ground bounce.
  • Direct interface with TTL levels (2.7 V to 3.6 V).
  • Bus hold on all data inputs.
  • Integrated 30 Ω termination resistor.
  • Complies with JEDEC standards:.
  • JESD8-5 (2.3 V to 2.7 V).
  • JESD8B/JESD36 (2.7 V to 3.

📥 Download Datasheet

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
74ALVCH162244 16-bit buffer/line driver with 30 Ω termination resistor; 3-State Rev. 3 — 16 January 2018 Product data sheet 1 General description The 74ALVCH162244 is a 16-bit non-inverting buffer/line driver with 3-state outputs. The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer. The 3-state outputs are controlled by the output enable inputs 1OE, 2OE, 3OE and 4OE. A HIGH on nOE causes the outputs to assume a high-impedance OFF-state. The 74ALVCH162244 is designed with 30 Ω series resistors in both HIGH and LOW output states. The 74ALVCH162244 has active bus hold circuitry which is provided to hold unused or floating data inputs at a valid logic level. This feature eliminates the need for external pull-up or pull-down resistors.