Audio outputs terminal (sub/rear switchable)
Power antenna relay control terminal
Power amplifier control terminal
Telephone ATT control terminal (GT317EE)
BUS control input terminal
BUS audio input terminal
Antenna input terminal
AUX input jack (stereo mini jack)
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
12 V DC car battery (negative ground)
Approx. 178 × 50 × 179 mm
(7 1/8 × 2 × 7 1/8 in.) (w/h/d)
Approx. 182 × 53 × 162 mm
(7 1/4 × 2 1/8 × 6 1/2 in.) (w/h/d)
Approx. 1.2 kg (2 lb. 11 oz.)
Card remote commander: RM-X151
Parts for installation and connections (1 set)
Design and specifications are subject to change without
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential dif ference g enerated b y the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
The flexible board is easily damag ed and should be handled with
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, w hen c hecking the laser diode emission,
observe from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
•N otice that the minus side of a tantalum capacitor may be damaged
Please use the following test discs for the check on the CD section.
YDES-18 (Part No. 3-702-101-01)
PATD-012 (Part No. 4-225-203-01)
Use of controls or adjustments or performance of procedures
other than those specif ied herein ma y result in hazardous
If the optical pic k-up block is defecti ve, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical pick-
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMA TIC DIAGRAMS AND IN
THE P ARTS LIST ARE CRITICAL T O SAFE OPERA TION.
REPLACE THESE COMPONENTS WITH SONY
WHOSE P ART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.