CDX-GT315C
http://www.xiaoyu163.com
MW/LW (AEP, UK model)
QQ 376315150Tuningrange
MW: 531 – 1,602 kHz
892498299SERVICE NOTES
LW: 153 – 279 kHz
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
Antenna terminal
External antenna connector
OR BASE UNIT
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
MW: 30 µV, LW: 40 µV
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential dif ference genera ted b y the
MW (E model)
charged electrostatic load, etc. on clothing and the human body.
Tuning range
531 – 1,602 kHz (at 9 kHz step)
During repair, pay attention to electrostatic breakdown and also use
530 – 1,710 kHz (at 10 kHz step)
the procedure in the printed matter which is included in the repair
MW tuning interval 9 kHz/10 kHz switchable
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 µV
parts.
The flexible board is easily damag ed and should be handled with
care.
SW (E model)
Tuning range
SW1: 2,940 – 7,735 kHz
SW2: 9,500 – 18,135 kHz
(except for 10,140 – 11,575 kHz)
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 µV
Power amplifier section
Outputs
Speaker outputs (sure seal connectors)
Speaker impedance 4 – 8 ohms
Maximum power output
AEP, UK model: 50 W × 4 (at 4 ohms)
US, Canadian, E model: 52 W × 4 (at 4 ohms)
General
Outputs
Audio outputs terminal (sub/rear switchable)
Power antenna relay control terminal
Power amplifier control terminal
Inputs
Telephone ATT control terminal
TEL 13942296513(AEP, UK model)
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna input terminal
AUX input jack (stereo mini jack)
Tone controls
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements 12 V DC car battery (negative ground)
Dimensions
Approx. 178 × 50 × 179 mm
(7 1/8 × 2 × 7 1/8 in.) (w/h/d)
Mounting dimensions Approx. 182 × 53 × 162 mm
(7 1/4 × 2 1/8 × 6 1/2 in.) (w/h/d)
Mass
Approx. 1.2 kg (2 lb. 11 oz.)
Supplied accessories Card remote commander: RM-X151
Parts for installation and connections (1 set)
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, w hen c hecking the laser diode emission,
observe from more than 30 cm away from the objective lens.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specif ied herein ma y result in hazardous
radiation exposure.
If the optical pic k-up block is defecti ve, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical pick-
up block.
QQ 376315150 892498299optical pick-up
Design and specifications are subject to change without
notice.
semi-fixed resistor
SAFETY-RELATED COMPONENT WARNING!!
ATTENTION AU COMPOSANT AYANT RAPPORT
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE P ARTS LIST ARE CRITICAL TO SAFE OPERA TION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
www . xiaoy u163. comPART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMA TIQUES ET LA LISTE DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLA CER CES COMPOSANTS Q UE PAR DES PIÈCES
IN SUPPLEMENTS PUBLISHED BY SONY.
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
2
http://www.xiaoyu163.com