Datasheet4U Logo Datasheet4U.com

MAX9972 - 300Mbps ATE Drivers/Comparators

General Description

The MAX9972 four-channel, ultra-low-power, pin-electronics IC includes, for each channel, a three-level pin driver, a window comparator, a passive load, and force-and-sense Kelvin-switched parametric measurement unit (PMU) connections.

Key Features

  • a -2.2V to +5.2V voltage range, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low voltage swings. The window comparator features 500MHz equivalent input bandwidth and programmable output voltage levels. The passive load provides pullup and pulldown voltages to the device-under-test (DUT). Low-leakage, high-impedance, and terminate controls are operational configurations that are programmed through a 3-wire, low-voltage, CMOS-compatible seria.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX997 Beyond-the-Rails Comparators Maxim
MAX9975 ATE Driver/Comparator Maxim
MAX9977 ATE Driver Maxim
MAX9979 Dual 1.1Gbps Pin Electronics Maxim Integrated
MAX990 Micropower / Low-Voltage / SOT23 / Rail-to-Rail I/O Comparators Maxim

Other Datasheets by Maxim Integrated (Analog Devices)

Part Number Description
MAX9971 300Mbps ATE Drivers/Comparators
MAX9973 (MAX9973 / MAX9974) Dual Driver / Comparator / Load
MAX9974 (MAX9973 / MAX9974) Dual Driver / Comparator / Load
MAX9910 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps
MAX9911 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MAX9972 Quad, Ultra-Low-Power, 300Mbps ATE Drivers/Comparators General Description The MAX9972 four-channel, ultra-low-power, pin-electronics IC includes, for each channel, a three-level pin driver, a window comparator, a passive load, and force-and-sense Kelvin-switched parametric measurement unit (PMU) connections. The driver features a -2.2V to +5.2V voltage range, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low voltage swings. The window comparator features 500MHz equivalent input bandwidth and programmable output voltage levels. The passive load provides pullup and pulldown voltages to the device-under-test (DUT).