HR1000A Datasheet | Monolithic Power Systems

The Future of Analog IC Technology Resonant Half-Bridge Controller DESCRIPTION The HR1000A is a controller designed specifically for the resonant half-bridge topology. It provides two drive-signal channels that output plementary signals at a 50% duty cycle. An internal fixed dead-time of 350ns between the two plementary gate signals guarantees zero-voltage switching during the transient and enables high-frequency operation. The integrated bootstrap diode simplifies the external driving circuit for the high-side switch. It can withstand up to 600V with immunity against high d V/dt noise. Modulating the switching frequency regulates the topology output voltage. A programmable oscillator can set both the maximum and minimum switching frequencies. The IC starts up at the programmed maximum switching frequency and gradually slows until the control loop takes over to prevent excessive inrush current The IC can be forced to enter a controlled burstmode operation at light-load to minimize the power consumption and tighten output regulation. Protections Features - including latched shutdown, auto-recovery, brown-out protection, and overtemperature protection- improve converter design safety without engendering additional circuit plexity. The IC provide 1.5A/2A source/sink capability for both high-side and low-side gate drivers. The HR1000A is available in a SO-16 package. Features - 50% Duty Cycle, Variable Frequency Control For Resonant Half-Bridge Converter - 600V High-Side Gate Driver with Integrated Bootstrap Diode and High d V/dt Immunity - 1.5A/2A Source/Sink Capability for Both High-Side and Low-Side Gate Drivers - High-Accuracy Oscillator - Operates at up to 600k Hz - Two-Level Over-Current Protection: Frequency-Shift and Latched Shutdown with Programmable Duration Time - Remote ON/OFF Control and Brown-Out Protection through the BO Pin - Latched-Disable Input for Easy Protections Implementation - Interfaces with PFC Controller - Programmable...