Datasheet4U Logo Datasheet4U.com

AP2201 - PFM Control Step-Up Switching Regulator

Description

The AP2201 Series is a CMOS PFM-control step-up switching regulator that mainly consists of a reference voltage source, an oscillator, and a comparator, enabling products with a low ripple over a wide range, high efficiency, and high output current.

Features

  • z Low voltage operation: Startup at 0.9 V min (Iout 1 mA) guaranteed z Low input current: 2.3uA (Vout 3.3 V) z Duty ratio: 75 % Built-in fixed-type PFM controller z External parts: Coil, capacitor, and diode z Output voltage: Settable to between 1.5 to 6.0V accuracy of 2%.

📥 Download Datasheet

Datasheet Details

Part number AP2201
Manufacturer Chipown
File Size 251.03 KB
Description PFM Control Step-Up Switching Regulator
Datasheet download datasheet AP2201 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AP2201 RF ULDO REGULATOR BCD Semiconductor
AP2202 RF ULDO REGULATOR BCD Semiconductor
AP2202 150mA RF ULDO REGULATOR Diodes
AP2203 RF ULDO REGULATOR BCD Semiconductor
AP220309 4A LOAD SWITCH DIODES

Other Datasheets by Chipown

Part Number Description
AP2000 Micropower Synchronous Step-Up Converter
AP2002 1.2MHz 1V Low Input Voltage Synch Step-Up Converter
AP2004 3A Step Up Regulator
AP2004H 3A Boost Converter
AP2007 Rectifier Step Up Converter

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
AP2201 Chipown Super Small Package PFM Control Step-Up Switching Regulator General Description The AP2201 Series is a CMOS PFM-control step-up switching regulator that mainly consists of a reference voltage source, an oscillator, and a comparator, enabling products with a low ripple over a wide range, high efficiency, and high output current. Products with a fixed duty ratio of 75 % （ Lower Output Voltage ） or 88%(Higher Output Voltage) are also available. With the AP2201 Series, a step-up switching regulator can be configured by using an external coil, capacitor, and diode. A protection circuit turns off the built-in MOS FET when the voltage at the CONT pin exceeds the limit to prevent it from being damaged.