Datasheet4U Logo Datasheet4U.com

HMC346AMS8GE - GaAs MMIC SMT VOLTAGE-VARIABLE ATTENUATOR

Description

The HMC346AMS8GE is absorptive Voltage Variable Attenuators (VVA) in 8 lead surface-mount packages operating from DC - 8 GHz.

Features

  • Wide Bandwidth: DC - 8 GHz Low Phase Shift vs. Attenuation 32 dB Attenuation Range Functional Diagram General.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HMC340LP5 GaAs MMIC SMT DOUBLE-BALANCED DUAL MIXER Hittite Microwave Corporation
HMC342 GaAs MMIC LOW NOISE AMPLIFIER Hittite Microwave Corporation
HMC345ALP3E GaAs MMIC SP4T NON-REFLECTIVE POSITIVE CONTROL SWITCH Hittite Microwave
HMC349LP4C HIGH ISOLATION SPDT NON-REFLECTIVE SWITCH Hittite Microwave Corporation
HMC349MS8G HIGH ISOLATION SPDT NON-REFLECTIVE SWITCH Hittite Microwave Corporation

Other Datasheets by Analog Devices

Part Number Description
HMC346ALC3B GaAs MMIC VOLTAGE-VARIABLE ATTENUATOR
HMC346ALP3E GaAs MMIC VOLTAGE-VARIABLE ATTENUATOR
HMC346 GaAs MMIC VOLTAGE-VARIABLE ATTENUATOR
HMC346C8 GaAs MMIC SMT VOLTAGEVARIABLE ATTENUATOR
HMC346G8 GaAs MMIC HERMETIC SMT VOLTAGEVARIABLE ATTENUATOR

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
ATTENUATORS - SMT PRELIMINARY v01.0117 8 Typical Applications This attenuator is ideal for use as a VVA for DC - 8 GHz applications: • Point-to-Point Radio • VSAT Radio HMC346AMS8GE GaAs MMIC SMT VOLTAGE-VARIABLE ATTENUATOR, DC - 8 GHz Features Wide Bandwidth: DC - 8 GHz Low Phase Shift vs. Attenuation 32 dB Attenuation Range Functional Diagram General Description The HMC346AMS8GE is absorptive Voltage Variable Attenuators (VVA) in 8 lead surface-mount packages operating from DC - 8 GHz. It features an on-chip reference attenuator for use with an external op-amp to provide simple single voltage attenuation control, 0 to -5V. The device is ideal in designs where an analog DC control signal must control RF signal levels over a 30 dB amplitude range.
Published: |