http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf




National Semiconductor Electronic Components Datasheet

LM2453 Datasheet

Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking

No Preview Available !

LM2453 pdf
April 2000
LM2453
Monolithic Triple 6 nS CRT Driver With Integrated Clamp
and G1 Blanking
General Description
The AC2DC driver is an integrated high voltage triple CRT
driver circuit designed for use in color monitor applications.
The input signal interface to the IC is a multiplexed signal
containing both clamp and video signal information, relative
to a 1.7 VDC reference.
The IC contains three high gain, high input impedance, wide
band amplifiers which directly drive the RGB cathodes of a
CRT. Each channel has its gain internally set to −52 and can
drive CRT capacitive loads as well as resistive loads present
in other applications, limited only by the package’s power
dissipation.
Integrated with the driver is triple clamp circuit for DC recov-
ery of each of the AC coupled outputs. The DC clamp circuit
amplifies the clamp signal that is multiplexed on the video
signal input. The DC clamp amplifiers are high gain, high in-
put impedance amplifiers, setting a low impedance DC level
at the clamp output which can be used to restore the DC
level of the cathode drive. Each channel has a gain that is in-
ternally set to +73.
Also integrated within the package is a 40 VP-P vertical
blanking driver that is designed to provide vertical retrace
blanking on G1 of the CRT. This is a current limited, low im-
pedance output capable of driving normal G1 decoupling ca-
pacitances via an external resistor. The output of the G1
driver can also be used to drive a voltage boost capacitor (22
µF). When connected between the G1 drive output and the
120V supply input pin, a 120V boost supply is achieved
which can be used to drive the internal DC clamp circuit,
thereby eliminating the requirement for a 120V clamp supply.
The IC is packaged in an industry standard 15-lead TO-220
molded plastic power package.
Features
n Low power dissipation
n Well matched with LM1253A video pre-amp
n Three wideband video amplifiers
n Three integrated active clamp circuits
n Convenient TO-220 staggered lead package
n Built in horizontal blanking
n Integrated 120V supply and G1 vertical blank drive
circuit
Applications
n 1280 x 1024 Resolution displays up to 85 Hz refresh
n Pixel clock frequencies up to 135 MHz
n Monitors requiring horizontal video blanking
Block Diagram
Package Pinout
DS101302-1
FIGURE 1. LM2453 Block Diagram
© 2000 National Semiconductor Corporation DS101302
DS101302-2
FIGURE 2. LM2453 Package Pinout
Order Number LM2453TA
www.national.com


National Semiconductor Electronic Components Datasheet

LM2453 Datasheet

Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking

No Preview Available !

LM2453 pdf
Special Features
MULTIPLEXED VIDEO SIGNAL INPUT
The LM2453 accepts the multiplexed video signal from the
LM1253 which contains the video signal and DC clamp level.
This multiplexed signal is shown in Figure 3. It was designed
to simplify the interface between the pre-amp and CRT
Driver. Slightly over 1V of dynamic range is provided for the
video and OSD portions of the waveform. The clamp signal
control voltage range is approximately 0.9V. The typical
numbers for the black and white levels shown correspond to
a nominal swing of 40 VP-P (from 25 to 65) at the video out-
puts of the LM2453. The clamp pulse lower level is used to
set the voltage at the clamp outputs of the LM2453.
DS101302-3
FIGURE 3. National LM1253 Multiplexed Video Signal
www.national.com
2


Part Number LM2453
Description Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking
Maker National Semiconductor
Total Page 14 Pages
PDF Download
LM2453 pdf
Download PDF File
LM2453 pdf
View for Mobile



Buy Electronic Components




Related Datasheet

1 LM2450 LM2450 220V Monolithic Triple Channel 7 MHz DC Coupled CRT DTV Driver (Rev. D) Texas Instruments
Texas Instruments
LM2450 pdf
2 LM2450 220V Monolithic Triple Channel 7 MHz DC Coupled CRT DTV Driver National Semiconductor
National Semiconductor
LM2450 pdf
3 LM2451 LM2451 220V Monolithic Triple Channel 12 MHz DC Coupled CRT DTV Driver (Rev. I) Texas Instruments
Texas Instruments
LM2451 pdf
4 LM2451 220V Monolithic Triple Channel 12 MHz DC Coupled CRT DTV Driver National Semiconductor
National Semiconductor
LM2451 pdf
5 LM2452 LM2452 220V Monolithic Triple Channel 17 MHz DC Coupled CRT DTV Driver (Rev. F) Texas Instruments
Texas Instruments
LM2452 pdf
6 LM2452 220V Monolithic Triple Channel 17 MHz DC Coupled CRT DTV Driver National Semiconductor
National Semiconductor
LM2452 pdf
7 LM2453 Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking National Semiconductor
National Semiconductor
LM2453 pdf
8 LM2453 LM2453 Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking (Rev. A) Texas Instruments
Texas Instruments
LM2453 pdf
9 LM2453TA Monolithic Triple 6 nS CRT Driver With Integrated Clamp and G1 Blanking National Semiconductor
National Semiconductor
LM2453TA pdf






Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

site map

webmaste! click here

contact us

Buy Components