Datasheet4U Logo Datasheet4U.com

NCP330 - Soft-Start Controlled Load Switch

Description

Pin Name Pin Number Type IN 1 POWER GND EN OUT 2 POWER 3 INPUT 4 OUTPUT PAD1 POWER Description Power

switch input voltage; connect a 1 mF or greater ceramic capacitor from IN to GND as close as possible to the IC.

Features

  • 1.8 V.
  • 5.5 V Operating Range.
  • 30 mW N.
  • MOSFET.
  • DC Current Up to 3 A.
  • Peak Current Up to 5 A.
  • Built.
  • in Soft.
  • Start 2 ms.
  • Reverse Voltage Protection.
  • Active High with Integrated Bridge.
  • Compliance to IEC61000.
  • 4.
  • 2 (Level 4) 8.0 kV (Contact) 15 kV (Air).
  • ESD Ratings: Machine Model = B Human Body Model = 3.
  • mDFN4 1.2 x 1.6 mm.
  • NCV Prefix for Automotive and Other.

📥 Download Datasheet

Datasheet Details

Part number NCP330
Manufacturer onsemi
File Size 375.68 KB
Description Soft-Start Controlled Load Switch
Datasheet download datasheet NCP330 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NCP304 Voltage Detector ON
NCP305 Voltage Detector ON
NCP3296 40A Stackable Synchronous Buck Regulator onsemi
NCP345 Overvoltage Protection ON
NCP346 Overvoltage Protection onsemi

Other Datasheets by onsemi

Part Number Description
NCP333 1.5A Ultra-Small Controlled Load Switch
NCP3334 Adjustable Low Dropout Regulator
NCP3334A Low Dropout Regulator
NCP3335 Low Dropout Regulator
NCP3335A Low Dropout Regulator

Full PDF Text Transcription

Click to expand full text
Soft-Start Controlled Load Switch NCP330 The NCP330 is a low Ron N−channel MOSFET controlled by a soft−start sequence of 2 ms for mobile applications. The very low RDS(on) allows system supplying or battery charging up to DC 3A.The device is enable automatically if a Power Supply is connected on Vin pin (active High) and maintained off if no Vin (internal pull down). Due to a current consumption optimization, leakage current is drastically decreased from the battery connected to the device, allowing long battery life. Features  1.8 V − 5.5 V Operating Range  30 mW N−MOSFET  DC Current Up to 3 A  Peak Current Up to 5 A  Built−in Soft−Start 2 ms  Reverse Voltage Protection  Active High with Integrated Bridge  Compliance to IEC61000−4−2 (Level 4) 8.
Published: |