Datasheet4U Logo Datasheet4U.com

LF398 - Monolithic Sample-and-Hold Circuits

Description

The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize BI-FET technology to obtain ultra-high dc accuracy with fast acquisition of signal and low droop rate.

Operating as a unity gain follower, dc gain accuracy is 0.002% typical and acquisition time is as low as 6 µs to 0.01%.

Features

  • n Operates from ±5V to ±18V supplies n Less than 10 µs acquisition time n TTL, PMOS, CMOS compatible logic input n 0.5 mV typical hold step at Ch = 0.01 µF n Low input offset n 0.002% gain accuracy n Low output noise in hold mode n Input characteristics do not change during hold mode n High supply rejection ratio in sample or hold n Wide bandwidth n Space qualified, JM38510 Logic inputs on the LF198 are fully differential with low input current, allowing direct connection to TTL, PMOS, and CMOS.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LF398 Sample-and-hold amplifiers NXP
LF398 MONOLITHIC SAMPLE AND HOLD CIRCUITS ETC
LF398 Precision Sample and Hold Amplifier Linear Technology
LF398-N LF298 LFx98x Monolithic Sample-and-Hold Circuits (Rev. B) ETCTI
LF398A Precision Sample and Hold Amplifier Linear Technology

Other Datasheets by National Semiconductor (Texas Instruments)

Part Number Description
LF398A Monolithic Sample-and-Hold Circuits
LF311 Voltage Comparators
LF347M Wide Bandwidth Quad JFET Input Operational Amplifiers
LF347N Wide Bandwidth Quad JFET Input Operational Amplifiers
LF353 Wide Bandwidth Dual JFET Input Operational Amplifier

Full PDF Text Transcription

Click to expand full text
LF198/LF298/LF398, LF198A/LF398A Monolithic Sample-and-Hold Circuits July 2000 LF198/LF298/LF398, LF198A/LF398A Monolithic Sample-and-Hold Circuits General Description The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize BI-FET technology to obtain ultra-high dc accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, dc gain accuracy is 0.002% typical and acquisition time is as low as 6 µs to 0.01%. A bipolar input stage is used to achieve low offset voltage and wide bandwidth. Input offset adjust is accomplished with a single pin, and does not degrade input offset drift. The wide bandwidth allows the LF198 to be included inside the feedback loop of 1 MHz op amps without having stability problems.
Published: |