Datasheet4U Logo Datasheet4U.com

RA07H4452M - RoHS Compliance

Description

The RA07H4452M is a 7-watt RF MOSFET Amplifier Module for 12.5-volt portable radios that operate in the 440- to 520-MHz range.

The battery can be connected directly to the drain of the enhancement-mode MOSFET transistors.

Features

  • Enhancement-Mode MOSFET Transistors (IDD≅0 @ VDD=12.5V, VGG=0V).
  • Pout>7W @ VDD=12.5V, VGG=3.5V, Pin=20mW.
  • ηT>40% @ Pout=7W (VGG control), VDD=12.5V, Pin=20mW.
  • Broadband Frequency Range: 440-520MHz www. DataSheet4U. com.
  • Low-Power Control Current IGG=1mA (typ) at VGG=3.5V.
  • Module Size: 30 x 10 x 5.4 mm.
  • Linear operation is possible by setting the quiescent drain current with the gate voltage and controlling the output power with the in.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
RA07H4047M 400-470MHz 7W 12.5V/ 2 Stage Amp. For PORTABLE/ MOBILE RADIO Mitsubishi Electric Semiconductor
RA07H4047M-01 400-470MHz 7W 12.5V/ 2 Stage Amp. For PORTABLE/ MOBILE RADIO Mitsubishi Electric Semiconductor
RA07H4047M-E01 400-470MHz 7W 12.5V/ 2 Stage Amp. For PORTABLE/ MOBILE RADIO Mitsubishi Electric Semiconductor
RA07H0608M MITSUBISHI RF MOSFET MODULE Mitsubishi Electric Semiconductor
RA07M1317M Silicon RF Power Modules Mitsubishi Electric Semiconductor

Other Datasheets by Mitsubishi Electric

Part Number Description
RA07H3340M RF MOSFET MODULE 330-400MHz 7W 12.5V PORTABLE/ MOBILE RADIO
RA07M0608M RoHS Compliance
RA07M3843M RoHS Compliance
RA07M4047M RoHS Compliance
RA07M4452M Silicon RF Power Modules

Full PDF Text Transcription

Click to expand full text
MITSUBISHI RF MOSFET MODULE ELECTROSTATIC SENSITIVE DEVICE OBSERVE HANDLING PRECAUTIONS RA07H4452M BLOCK DIAGRAM 2 3 RoHS Compliance ,440-520MHz 7W 12.5V, 2 Stage Amp. For PORTABLE RADIO DESCRIPTION The RA07H4452M is a 7-watt RF MOSFET Amplifier Module for 12.5-volt portable radios that operate in the 440- to 520-MHz range. The battery can be connected directly to the drain of the enhancement-mode MOSFET transistors. Without the gate voltage (VGG=0V), only a small leakage current flows into the drain and the RF input signal attenuates up to 60 dB. The output power and drain current increase as the gate voltage increases. With a gate voltage around 2.5V (minimum), output power and drain current increases substantially. The nominal output power becomes available at 3V (typical) and 3.
Published: |