D111EI - (D111EI Series) High Isolation SIP DC/DC Converters
MicroPower Direct
Key Features
1W Output Power.
3,000 VDC Isolation.
Miniature SIP Case.
Single & Dual Outputs.
>1 MHour MTBF.
24 Standard Models.
LOWEST COST!!
Parameter Input Voltage Range Input Filter Reverse Polarity Input Current
Internal Capacitor
Output
Parameter Output Voltage Accuracy Output Voltage Balance Line Regulation Load Regulation (Note 1) Ripple & Noise (20 MHz) (Note 2) Output Power Protection Temperature Coefficient Output Short Circuit
See Model Selection Guide
Gen.
Full PDF Text Transcription for D111EI (Reference)
Note: Below is a high-fidelity text extraction (approx. 800 characters) for
D111EI. For precise diagrams, and layout, please refer to the original PDF.
D100EI Series Low Cost, 1W High Isolation SIP DC/DC Converters Electrical Specifications Specifications typical @ +25°C, nominal input voltage & rated output current, unles...
View more extracted text
s typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice. New Budget Saver!! Conditions 5 VDC Input 12 VDC Input 24 VDC Input Min. 4.5 10.8 21.6 Typ. 5.0 12.0 24.0 Max. 5.5 13.2 26.4 0.3 Conditions Dual Output , Balanced Loads For Vin Change of 1% Min. Typ. ±1.0 ±0.1 ±1.2 50 120 ±0.02 Momentary (1.0 Sec.) Conditions 60 Seconds 500 VDC 100 kHz, 1V 100 Conditions Ambient Case Min. -40 -40 -55 Free Air Convection RH, Non-condensing 95 % Min. 3,000 1,000 60 150 Typ. +25 200 Max. +85 +90 +125 Typ. Max. Units VDC pF kHz Units ºC ºC ºC MΩ ±0.03 75 Max.
D111EI Datasheet
