Datasheet4U Logo Datasheet4U.com

IP82C84A - CMOS Clock Generator Driver

Description

The Intersil 82C84A is a high performance CMOS Clock Generatordriver which is designed to service the requirements of both CMOS and NMOS microprocessors such as the 80C86, 80C88, 8086 and the 8088.

Features

  • Generates the System Clock For CMOS or NMOS Microprocessors.
  • Up to 25MHz Operation.
  • Uses a Parallel Mode Crystal Circuit or External Frequency Source.
  • Provides Ready Synchronization.
  • Generates System Reset Output From Schmitt Trigger Input.
  • TTL Compatible Inputs/Outputs.
  • Very Low Power Consumption.
  • Single 5V Power Supply.
  • Operating Temperature Ranges - C82C84A.
  • . . . . .0oC to +70.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
IP82C37A CMOS High Performance Programmable DMA Controller Harris Corporation
IP82C52 CMOS Serial Controller Interface Renesas
IP82C55A CMOS Programmable Peripheral Interface Harris Corporation
IP8155 2048-Bit Static MOS RAM with I/O Ports and Timer Advanced Micro Devices
IP8155H 2048-Bit Static MOS RAM with I/O Ports and Timer Advanced Micro Devices

Other Datasheets by Intersil (Renesas)

Part Number Description
IP82C82 CMOS Octal Latching Bus Driver
IP82C83H CMOS Octal Latching Inverting Bus Driver
IP82C86H CMOS Octal Bus Transceiver
IP82C87H CMOS Octal Inverting Bus Transceiver
IP82C88 CMOS Bus Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
82C84A March 1997 CMOS Clock Generator Driver Description The Intersil 82C84A is a high performance CMOS Clock Generatordriver which is designed to service the requirements of both CMOS and NMOS microprocessors such as the 80C86, 80C88, 8086 and the 8088. The chip contains a crystal controlled oscillator, a divide-bythree counter and complete “Ready” synchronization and reset logic. Static CMOS circuit design permits operation with an external frequency source from DC to 25MHz. Crystal controlled operation to 25MHz is guaranteed with the use of a parallel, fundamental mode crystal and two small load capacitors. All inputs (except X1 and RES) are TTL compatible over temperature and voltage ranges. Power consumption is a fraction of that of the equivalent bipolar circuits.
Published: |