Datasheet4U Logo Datasheet4U.com

HS9-26C31RH-Q - Radiation Hardened Quad Differential Line Driver

Description

only.

Intersil Corporation reserves the right to make changes in circuit design and/or specifications at any time without notice.

Accordingly, the reader is cautioned to verify that data sheets are current before placing orders.

Features

  • Electrically Screened to SMD # 5962-96663.
  • QML Qualified per MIL-PRF-38535 Requirements.
  • 1.2 Micron Radiation Hardened CMOS - Total Dose Up to.
  • 300kRAD(Si) - Dose Rate Upset.
  • . . > 1x109 RAD/s (20ns Pulse).
  • Latchup Free.
  • EIA RS-422 Compatible Outputs (Except for IOS).
  • CMOS Inputs.
  • High Impedance Outputs when Disabled or Powered Down.
  • Low Power Dissipation.
  • . . . . 2.75mW Sta.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HS9-82C37ARH-8 Radiation Hardened CMOS High Performance Programmable DMA Controller Harris Corporation
HS9-82C37ARH-Q Radiation Hardened CMOS High Performance Programmable DMA Controller Harris Corporation
HS9016 10/100 Small Package Transformer module Magcom
HS9016 HS9016 ETC
HS9147x RES NTWK / THICK FILM Stackpole Electronics

Other Datasheets by Intersil (Renesas)

Part Number Description
HS9-26C31RH-8 Radiation Hardened Quad Differential Line Driver
HS9-26C31RH-T Radiation Hardened Quad Differential Line Driver
HS9-26C31RH Radiation Hardened Quad Differential Line Driver
HS9-26C31RH Radiation Hardened Quad Differential Line Driver
HS9-26C32RH Radiation Hardened Quad Differential Line Receiver

Full PDF Text Transcription

Click to expand full text
HS-26C31RH Data Sheet August 1999 File Number 3401.3 Radiation Hardened Quad Differential Line Driver The Intersil HS-26C31RH is a quad differential line driver designed for digital data transmission over balanced lines and meets the requirements of EIA standard RS-422. Radiation hardened CMOS processing assures low power consumption, high speed, and reliable operation in the most severe radiation environments. The HS-26C31RH accepts CMOS signal levels and converts them to RS-422 compatible outputs. This circuit uses special outputs that enable the drivers to power down without loading down the bus. Enable and disable pins allow several devices to be connected to the same data source and addressed independently.
Published: |