Datasheet4U Logo Datasheet4U.com

ILX485 - Drivers/Receiver

Description

The ILX485 is low-power transceivers for RS-485 and RSw 422 communication.

IC contains one driver and one receiver.

These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers.

Features

  • Low Quiescent Current: 300µA -7V to +12V Common-Mode Input Voltage Range Three-State Outputs 30ns Propagation Delays, 5ns Skew Full-Duplex and Half-Duplex Versions Available Operate from a Single 5V Supply Allows up to 32 Transceivers on the Bus Data rate: 2,5 Mbps Current-Limiting and Thermal Shutdown for Driver Overload Protection w w w t a . D S a e h U 4 t e.

📥 Download Datasheet

Datasheet Details

Part number ILX485
Manufacturer IK Semiconductor
File Size 247.79 KB
Description Drivers/Receiver
Datasheet download datasheet ILX485 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ILX103A 3000-pixel CCD Linear Image Sensor Sony
ILX115LA 5000-pixel X 3 line CCD Linear Sensor Sony Corporation
ILX128MA 5350-pixel X 6-line CCD Linear Sensor Sony Corporation
ILX137K 10700-pixel x 6-line CCD Linear Sensor Sony
ILX146K The Industrys First Digital Copier CCD Linear Sensor ETC

Other Datasheets by IK Semiconductor

Part Number Description
ILX485D Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX485DT Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX485N Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX232 Drivers/Receivers
ILX3085 Interface Transceiver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
w them to transmit up to 2.5Mbps. U 4 t Slew-Rate-Limited RS-485/RS-422 Low-Power, e e Transceivers h S a t a General .D Description The ILX485 is low-power transceivers for RS-485 and RSw 422 communication. IC contains one driver and one receiver. w The driver slew rates of the ILX485 is not limited, allowing These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers. All parts operate from a single 5V supply. Drivers are short-circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.
Published: |