Datasheet4U Logo Datasheet4U.com

KA7500B - SMPS Controller

General Description

The KA7500B is used for the control circuit of the PWM switching regulator.

The KA7500B consists of 5V reference voltage circuit, two error amplifiers, a flip flop, an output control circuit, a PWM comparator, a dead time comparator and an oscillator.

Key Features

  • Internal Regulator Provides a Stable 5V Reference Supply Trimmed to 5%.
  • Uncommitted Output TR for 200mA Sink or Source Current.
  • Output Control For Push-Pull or Single Ended Operation.
  • Variable Duty Cycle By Dead Time Control (Pin 4) Complete PWM Control Circuit.
  • On-Chip Oscillator With Master or Slave Operation.
  • Internal Circuit Prohibits Double Pulse at Either Output.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
KA7500B VOLTAGE-MODE PWM CONTROLLER Samsung
KA7500 single monolithic chip HUAFUQIN
KA7500 Switching - type pulse width control circuit H&M Semiconductor
KA7500 single monolithic chip Estek Electronics
KA7521 ELECTRONIC BALLAST CONTROLLER Fairchild Semiconductor

Other Datasheets by Fairchild (now onsemi)

Part Number Description
KA7500C SMPS Controller
KA7511 SMPS Controller
KA7515 SMPS Controller
KA7524B Power Factor Correction Controller
KA75250 Voltage Detector

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.fairchildsemi.com KA7500B SMPS Controller Features • Internal Regulator Provides a Stable 5V Reference Supply Trimmed to 5% • Uncommitted Output TR for 200mA Sink or Source Current • Output Control For Push-Pull or Single Ended Operation • Variable Duty Cycle By Dead Time Control (Pin 4) Complete PWM Control Circuit • On-Chip Oscillator With Master or Slave Operation • Internal Circuit Prohibits Double Pulse at Either Output Description The KA7500B is used for the control circuit of the PWM switching regulator. The KA7500B consists of 5V reference voltage circuit, two error amplifiers, a flip flop, an output control circuit, a PWM comparator, a dead time comparator and an oscillator. This device can be operated in the switching frequency of 1kHz to 300kHz.