Datasheet4U Logo Datasheet4U.com

UDN2916 - DUAL FULL-BRIDGE PWM MOTOR DRIVER

Key Features

  • I I I I I I I 750 mA Continuous Output Current 45 V Output Sustaining Voltage Internal Clamp Diodes Internal PWM Current Control Low Output Saturation Voltage Internal Thermal Shutdown Circuitry Similar to Dual PBL3717, UC3770 Always order by complete part number: Part Number Package UDN2916B 24-Pin DIP UDN2916EB 44-Lead PLCC UDN2916LB 24-Lead SOIC 2916 DUAL FULL-BRIDGE MOTOR DRIVER UDN2916EB LOGIC SUPPLY LOAD SUPPLY SENSE 1 PHASE 1 OUT 1A OUT 1B VREF 1.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
UDN2916A STEPPER MOTOR DRIVER ST Microelectronics
UDN2916B DUAL FULL-BRIDGE PWM MOTOR DRIVER Sprague

Other Datasheets by Allegro MicroSystems

Part Number Description
UDN2917 DUAL FULL-BRIDGE PWM MOTOR DRIVER
UDN2943 HIGH-CURRENT HALF-BRIDGE MOTOR DRIVER
UDN2944 HIGH-VOLTAGE SOURCE DRIVER
UDN2944W HIGH-VOLTAGE SOURCE DRIVER
UDN2953 FULL-BRIDGE PWM MOTOR DRIVERS
UDN2953B FULL-BRIDGE PWM MOTOR DRIVERS
UDN2954 FULL-BRIDGE PWM MOTOR DRIVERS
UDN2954W FULL-BRIDGE PWM MOTOR DRIVERS
UDN2985 8-CHANNEL SOURCE DRIVER
UDN2987 8-CHANNEL SOURCE DRIVER WITH OVER-CURRENT PROTECTION

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
2916 UDN2916B OUT 1A OUT 2A E2 SENSE 2 OUT 2B GROUND GROUND I 02 DUAL FULL-BRIDGE PWM MOTOR DRIVER VBB LOAD SUPPLY E1 SENSE 1 OUT 1B I 01 GROUND GROUND I 11 PHASE 1 V REF 1 RC 1 LOGIC SUPPLY 1 2 3 4 5 6 7 8 2 24 23 1 22 21 20 19 18 17 The UDN2916B, UDN2916EB, and UDN2916LB motor drivers are designed to drive both windings of a bipolar stepper motor or bidirectionally control two dc motors. Both bridges are capable of sustaining 45 V and include internal pulse-width modulation (PWM) control of the output current to 750 mA. The outputs have been optimized for a low output saturation voltage drop (less than 1.8 V total source plus sink at 500 mA). For PWM current control, the maximum output current is determined by the user’s selection of a reference voltage and sensing resistor.