Datasheet4U Logo Datasheet4U.com

M62255FP - GENERAL PURPOSE BATTERY CHARGER CONTROL IC

Description

Notice: This is not a final specification.

Some parametric limits are subject to change.

Features

  • Built-in 3 wire serial data interface for MCU.
  • Built-in multiplexer and level magnification circuit with 4 input ports.
  • Built-in DC-DC converter circuit for PWM function.
  • Built-in two current detection circuits. These circuits can detect charge current and discharge current.
  • ON/OFF control with low power dissipation mode. (Power save) SW PGND OSC GND PS CK DI CS DCDOUT REF IN ADJ Vcc 1 2 3 4 5 6 7 8 9 10 11 12 24 23 22 21 20 19 18 17 16 15 14 13 Vc.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
M62253AGP Charge Control IC Mitsubishi Electric
M62203FP Two-Channel Fixed-Output General-Purpose DC-DC Converte Renesas Technology
M62235FP Standard Linear ICs Switching power supply secondary side control Renesas Technology
M62235P Standard Linear ICs Switching power supply secondary side control Renesas Technology
M62237FP CONSTANT VOLTAGE CONSTANT CURRENT CONTROLIC Renesas Technology

Other Datasheets by Mitsubishi Electric

Part Number Description
M62255 GENERAL PURPOSE BATTERY CHARGER CONTROL IC
M62253 LITHIUM ION BATTERY CHARGER CONTROL IC
M62253FP LITHIUM ION BATTERY CHARGER CONTROL IC
M62254 Standard Battery Charger Controller
M62254FP Standard Battery Charger Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
rod P w Ne DESCRIPTION uct TE A NT E V I T MITSUBISHI M62255FP GENERAL PURPOSE BATTERY CHARGER CONTROL IC Notice: This is not a final specification. Some parametric limits are subject to change. PIN CONFIGURATION (TOP VIEW) The M62255FP is intended to be used a general purpose battery charger control for Note PC. The M62255FP contains the functions which are required for the battery charge control ,on single chip using low peripheral component requirement . The M62255FP can handle battery charge control, monitor battery temperature and prevent from over current and voltage with microcomputer. It contains DC-DC converter circuit which can be used for the feedback control of the charge current and the output voltage. It is the best fit for Smart Battery Charger.