Datasheet4U Logo Datasheet4U.com

ET9600 - THREE CHANNEL DIFFERENTIAL LINE DRIVER IC

Description

These line drivers are similar to the four channel 26ET31, with the added feature of providing an internal LED drive.

The device is biased so that the base of the LED drive transistor (shown) is held at 2.5V.

To set the LED current, connect a resistor from RSET to ground.

Features

  • Supply Voltage Range 4.5V to 30V Operation to 800KHz CMOS and TTL Compatible Inputs Outputs RS-422A Compatible High Impedance Buffered Inputs with Hysteresis Outputs short circuit protected 70mA peak SINK/SOURCE current Outputs Protected by Thermal Shut-Down.

📥 Download Datasheet

Datasheet Details

Part number ET9600
Manufacturer ETIC
File Size 60.68 KB
Description THREE CHANNEL DIFFERENTIAL LINE DRIVER IC
Datasheet download datasheet ET9600 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ET9000 486 WRITE BACK CACHE AT SINGLE CHIP ETEQ
ET9235 Optimum CMOS IC Etek Microelectronics
ET9260 Optimum CMOS Etek Microelectronics
ET9364 High performance white LED driver Etek Microelectronics
ET9366 Constant frequency charge pump DC/DC converter Etek Microelectronics

Other Datasheets by ETIC

Part Number Description
ET9560 3 CHANNEL DIFFERENTIAL AMPLIFIER-COMPARATOR
ET9561 3 CHANNEL DIFFERENTIAL AMPLIFIER-COMPARATOR

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com THREE CHANNEL DIFFERENTIAL LINE DRIVER IC With built-in current sink to drive an LED ET9600 FEATURES • • • • • • • • Supply Voltage Range 4.5V to 30V Operation to 800KHz CMOS and TTL Compatible Inputs Outputs RS-422A Compatible High Impedance Buffered Inputs with Hysteresis Outputs short circuit protected 70mA peak SINK/SOURCE current Outputs Protected by Thermal Shut-Down APPLICATIONS • • Optical Encoders Industrial Controls DESCRIPTION These line drivers are similar to the four channel 26ET31, with the added feature of providing an internal LED drive. The device is biased so that the base of the LED drive transistor (shown) is held at 2.5V. To set the LED current, connect a resistor from RSET to ground.
Published: |