Datasheet4U Logo Datasheet4U.com

74CBTLV3861 - 10-bit bus switch

General Description

The 74CBTLV3861 is a 10-bit bus switch with one output enable (OE) input.

When OE is LOW, the switch is closed and port A is connected to the B port.

When OE is HIGH, the switch is disabled.

Key Features

  • Supply voltage range from 2.3 V to 3.6 V.
  • High noise immunity.
  • Complies with JEDEC standard:.
  • JESD8-5 (2.3 V to 2.7 V).
  • JESD8-B/JESD36 (2.7 V to 3.6 V).
  • ESD protection:.
  • HBM JESD22-A114F exceeds 2000 V.
  • MM JESD22-A115-A exceeds 200 V.
  • CDM AEC-Q100-011 revision B exceeds 1000 V.
  • 5 Ω switch connection between two ports.
  • Rail to rail switching on data I/O ports.
  • CMOS low power consumption.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
74CBTLV3861 LOW-VOLTAGE 10-BIT BUS SWITCH Renesas
74CBTLV3125 4-bit bus switch NXP
74CBTLV3126 4-bit Bus Switch NXP
74CBTLV3244 LOW-VOLTAGE OCTAL BUS SWITCH Renesas
74CBTLV3244 LOW-VOLTAGE OCTAL BUS SWITCH IDT

Other Datasheets by Nexperia

Part Number Description
74CBTLV3125 4-bit bus switch
74CBTLV3125-Q100 4-bit bus switch
74CBTLV3126 4-bit bus switch
74CBTLV3126-Q100 4-bit bus switch
74CBTLV3244 8-bit bus switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
74CBTLV3861 10-bit bus switch with output enable Rev. 5 — 16 February 2021 Product data sheet 1. General description The 74CBTLV3861 is a 10-bit bus switch with one output enable (OE) input. When OE is LOW, the switch is closed and port A is connected to the B port. When OE is HIGH, the switch is disabled. To ensure the high-impedance OFF-state during power-up or power-down, OE should be tied to the VCC through a pull-up resistor. The minimum value of the resistor is determined by the currentsinking capability of the driver. Schmitt trigger action at control input makes the circuit tolerant to slower input rise and fall times across the entire VCC range from 2.3 V to 3.6 V. This device is fully specified for partial power-down applications using IOFF.