Datasheet4U Logo Datasheet4U.com

74AVCH16244 - 16-bit buffer/line driver

General Description

The 74AVCH16244 is a 16-bit non-inverting buffer/line driver with 3-state outputs.

The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer.

The 3‑state outputs are controlled by the output enable inputs nOE.

Key Features

  • Wide supply voltage range from 1.2 V to 3.6 V.
  • CMOS low power consumption.
  • Low inductance multiple VCC and GND pins for minimum noise and ground bounce.
  • Input/output tolerant up to 3.6 V.
  • Dynamic controlled output (DCO) circuit dynamically changes the output impedance, resulting in noise reduction without speed degradation.
  • Bus hold on all data inputs.
  • Supports Live Insertion.
  • Complies with JEDEC standards:.
  • JESD8.

📥 Download Datasheet

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
74AVCH16244 16-bit buffer/line driver; 3.6 V tolerant; 3-state Rev. 2 — 20 February 2018 Product data sheet 1 General description The 74AVCH16244 is a 16-bit non-inverting buffer/line driver with 3-state outputs. The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer. The 3‑state outputs are controlled by the output enable inputs nOE. A HIGH on nOE causes the outputs to assume a high impedance OFF-state. The 74AVCH16244 is designed to have an extremely fast propagation delay and a minimum amount of power consumption. To ensure the high-impedance output state during power-up or power-down, nOE should be tied to VCC through a pull-up resistor (Live Insertion).