Datasheet4U Logo Datasheet4U.com

SN74AVC4T234 - 4-Bit Dual-Supply Unidirectional Noninverting Voltage Translator

Description

This 4-bit non-inverting bus transceiver uses two separate configurable power-supply rails to enable asynchronous communication between B-port inputs and A-port outputs.

The A port is designed to track VCCA while the B port is designed to track VCCB.

Features

  • Wide operating VCC range of 0.9 V to 3.6 V.
  • 3.6-V I/O Tolerant to support mixed-mode signal operation.
  • Max tpd of 3.7 ns at 3.3 V.
  • Balanced propagation delays: tPLH = tPHL.
  • Low static-power consumption, 5-μA Max ICC.
  • Outputs disabled if either VCC goes to 0V.
  • ±3-mA Output drive at 1.8 V.
  • 26-Ω series resistor on A-side outputs.
  • Ioff supports partial power-down-mode operation.
  • Input hysteresis allows slow in.

📥 Download Datasheet

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.ti.com SN74AVC4T234 SCES810B – JUNE 2011 – RSENV7IS4EADVJCUL4YT2203240 SCES810B – JUNE 2011 – REVISED JULY 2020 SN74AVC4T234 4-Bit Dual-Supply Unidirectional Noninverting Voltage Translator 1 Features • Wide operating VCC range of 0.9 V to 3.6 V • 3.6-V I/O Tolerant to support mixed-mode signal operation • Max tpd of 3.7 ns at 3.3 V • Balanced propagation delays: tPLH = tPHL • Low static-power consumption, 5-μA Max ICC • Outputs disabled if either VCC goes to 0V • ±3-mA Output drive at 1.8 V • 26-Ω series resistor on A-side outputs • Ioff supports partial power-down-mode operation • Input hysteresis allows slow input transition and better switching noise immunity at input • Maximum data rates – 380 Mbps (1.8-V to 3.3-V translation) – 200 Mbps (<1.8-V to 3.
Published: |