Datasheet4U Logo Datasheet4U.com

LM96550 - Ultrasound Transmit Pulser

Description

The LM96550 is an eight-channel monolithic highvoltage, high-speed pulse generator for multi-channel medical ultrasound applications.

It is well-suited for use with TI’s LM965XX series chipset which offers a complete medical ultrasound solution targeted towards low-power, portable systems.

Features

  • 1.
  • 2 8-Channel High-Voltage CMOS Pulse Generator.
  • Output Pulses with ±50V and 2A Peak Current.
  • Active Damper with Built-In Blocking Diodes.
  • Up to 15 MHz Operating Frequency.
  • Matched Delays for Rising and Falling Edges.
  • Low Second Harmonic Distortion Allows and Improves Harmonic Imaging.
  • Continuous-Wave (CW) Operation Down to ±3.3V.
  • Low Phase Noise Enables Doppler Measurements.
  • -145 dBc/Hz Phase Noise at 10 MHz (1 kHz.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LM96550 Ultrasound Transmit Pulser National Semiconductor
LM96511 Ultrasound Receive Analog Front-End National Semiconductor
LM96530 Ultrasound Transmit/Receive Switch National Semiconductor
LM96570 Ultrasound Configurable Transmit Beamformer National Semiconductor Corporation
LM96000 Hardware Monitor National Semiconductor

Other Datasheets by Texas Instruments

Part Number Description
LM96551 Ultrasound Transmit Pulser
LM96511 Ultrasound Receive Analog Front-End
LM96530 Ultrasound Transmit/Receive Switch
LM96570 Ultrasound Configurable Transmit Beamformer
LM96000 Hardware Monitor

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
LM96550 www.ti.com SNAS504F – AUGUST 2010 – REVISED MAY 2013 LM96550 Ultrasound Transmit Pulser Check for Samples: LM96550 FEATURES 1 •2 8-Channel High-Voltage CMOS Pulse Generator • Output Pulses with ±50V and 2A Peak Current • Active Damper with Built-In Blocking Diodes • Up to 15 MHz Operating Frequency • Matched Delays for Rising and Falling Edges • Low Second Harmonic Distortion Allows and Improves Harmonic Imaging • Continuous-Wave (CW) Operation Down to ±3.3V • Low Phase Noise Enables Doppler Measurements – -145 dBc/Hz Phase Noise at 10 MHz (1 kHz offset) • Output State Over-Temperature Protection • Blocking Diodes for Direct Interface to Transducer • 2.5V to 5.
Published: |