DLPC230-Q1
Overview
The DLPC23x-Q1 digital micromirror display (DMD) controller for automotive applications is used in chipsets for interior applications such as.
- Qualified for automotive applications
- AEC-Q100 qualified with the following results: - Device temperature grade 2: -40°C to 105°C ambient operating temperature - Device HBM ESD Classification Level 2 - Device CDM ESD Classification Level C4B
- DMD display controller supporting: - DLP553x-Q1 and DLP462x-Q1 automotive interior display and exterior lighting chipsets
- Video processing - Scales input image to Match DMD resolution - Bezel adjustment up ±50% vertical image position and ±10% horizontal reducing the need for mechanical alignment (HUD) - Support for pixel doubling or quadrupling to allow low resolution video input - Gamma correction
- Embedded processor with error correction (ECC) - On-chip diagnostic and self-test capability - System diagnostics including temperature monitoring, device interface monitoring, and photodiode monitoring - Integrated Management of Smooth Dimming - Configurable GPIO
- No external RAM required, internal SRAM for image processing
- 600-MHz Sub-LVDS DMD interface for low power and emission
- Spread spectrum clocking for reduced EMI
- Video input interface - Single OpenLDI (FPD-Link I) port up to 110 MHz - 24-bit RGB parallel interface up to 110 MHz
- Configurable host control interface - Serial Peripheral Interface (SPI) 10 MHz - I2C (400 kHz) - Host IRQ signal to provide real-time feedback for critical system errors
