Datasheet4U Logo Datasheet4U.com

ZSSC3008 - Sensor Signal Conditioner

Description

The ZSSC3008 is a sensor signal conditioner IC that is adjustable to nearly all piezo-resistive bridge sensors.

Measured and corrected bridge values are provided at the SIG™ pin, which can be configured as an analog voltage output or as a one-wire serial digital output.

Features

  • Digital compensation of sensor offset, sensitivity, and non-linearity.
  • Programmable analog gain and digital gain;.

📥 Download Datasheet

Datasheet Details

Part number ZSSC3008
Manufacturer Zentrum Mikroelektronik Dresden
File Size 745.58 KB
Description Sensor Signal Conditioner
Datasheet download datasheet ZSSC3008 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ZSSC3015 Sensor Signal Conditioner IDT
ZSSC3016 16-Bit Sensor Signal Conditioner IDT
ZSSC3018 High Resolution 18-Bit Sensor Signal Conditioner IDT
ZSSC3018 High Resolution 18-Bit Sensor Signal Conditioner Renesas
ZSSC3026 High Resolution 16-Bit Sensor Signal Conditioner IDT

Other Datasheets by Zentrum Mikroelektronik Dresden

Part Number Description
ZSSC3015 Sensor Signal Conditioner
ZSSC3016 High Resolution 16-Bit Sensor Signal Conditioner
ZSSC3026 High Resolution 16-Bit Sensor Signal Conditioner
ZSSC3036 High Resolution 16-Bit Sensor Signal Conditioner
ZSSC3122 Low Voltage Capacitive Sensor Signal Conditioner

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Data Sheet Rev. 1.11 / June 2011 ZSSC3008 Sensor Signal Conditioner with Diagnostics ZSSC3008 Sensor Signal Conditioner with Diagnostics Brief Description The ZSSC3008 is a sensor signal conditioner IC that is adjustable to nearly all piezo-resistive bridge sensors. Measured and corrected bridge values are provided at the SIG™ pin, which can be configured as an analog voltage output or as a one-wire serial digital output. The digital one-wire interface (OWI) can be used for a simple PC-controlled calibration procedure to program a set of calibration coefficients into an on-chip EEPROM. The calibrated ZSSC3008 and a specific sensor are mated digitally: fast, precise, and without the cost overhead associated with trimming by external devices or laser.
Published: |