3.0KP6.0CA Datasheet | Yint

atures - - - - - - - P600 glass passivated chip junction Plastic package Polarity:Color band denoted positive end (cathode) except Bidirectional. Typical failure mode is short from over-specified voltage or current Fast response time: typically less than 1.0ps from 0 Volts to BV min. High Temperature soldering:260°C/10 seconds at terminals. Solder dip 275 °C max. 10 s, per JESD 22-B106 Typical Applications Use in sensitive electronics protection against voltage transients induced by inductive load switching and lighting on ICs, MOSFET, signal lines of sensor units for consumer, puter, industrial, automotive, and telemunication. Electrical Characteristics (@ TA = 25°C Unless Otherwise Noted) Parameter Peak pulse power dissipation with a 10/1000 μs waveform Peak pulse current with a 10/1000 μs waveform Power dissipation on infinite heat sink at TL= 75 °C Peak forward surge current 8.3 ms single half sine-wave Instantaneous forward voltage at 100 A for Unidirectional only Operating junction and storage temperature range Symbol PPK IFSM PD Value Unit Watts Amps Watts Amps V °C See next table 7 300 3.5 -55 to +175 IFSM VF TJ ,TSTG Notes : (1)Non-repetitive current pulse, per fig. 6 and derated above TA = 25 °C per fig. 2 (2)Measured 8.3 ms single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum .yint..cn VER4.0 3KP Series Electrical Characteristics Reverse Part Number (Bi) Part Stand off Number Voltage VR (Uni) (Volts) Breakdown Voltage VBR (Volts)@IT Test Current IT(m A) Maximum Reverse Leakage IR@ VR(μ A) Maximum Peak Pulse Current I pp (A) Maximum Clamping Voltage VC@ pp(V) Min .V 6.40 6.67 8.99 11.10 12.20 13.30 16.70 17.80 20.00 22.20 24.40 26.70 28.90 31.10 33.30 36.70 40.00 44.40 47.80 53.30 56.70 60.00 66.70 71.10 77.80 83.30 100.00 111.00 133.00 144.00 167.00 178.00 200.00 222.00 244.00 Max .V 7.25 7.37 10.23 12.30 13.50 14.70 18.50 19.70 22.10 24.50 26.90 29.50 31.90 34.40 36.80 40.60 44.20 49.10 52.80...