Datasheet4U Logo Datasheet4U.com

CD4066 - QUAD BILATERAL SWITCH

General Description

The UTC CD4066 is a quad bilateral switch which can be applied for switching of analog signals and digital signals.

When control input CONT is set to “H” level, the impedance between input and output of the switch becomes low and when it is set to “L” level, the impedance becomes high.

Key Features

  • tal or ±7.5V Peak-to-Peak Switching.
  • 85-Ω Typical On-State Resistance for 15V Operation.
  • High noise immunity 0.45 VDD (typ. ).
  • Matched “ON” resistance ∆RON=5Ω (typ. ) over 15V signal input.
  • High degree linearity 0.1% distortion (typ. ) @ fIS=1kHz, VIS=5VP-P, VDD-VSS=5V, RL=10kΩ.
  • Extremely low “OFF” 0.1nA (typ. ) switch leakage: @ VDD-VSS=10V, TA=25°C.
  • Extremely high control input impedance 1012Ω (typ. ).
  • Frequency response, switch “ON” 40 MHz (typ. ).
  • ORDER.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
CD4066A CMOS Quad Bilateral Switch RCA
CD4066A A four-switch digital and analog signals ETC
CD4066B CMOS QUAD BILATERAL SWITCH RCA
CD4066B CMOS Quad Bilateral Switch Texas Instruments
CD4066B-Q1 CMOS Quad Bilateral Switch Texas Instruments

Other Datasheets by Unisonic Technologies

Part Number Description
CD4081B QUAD 2-INPUT AND GATE
CD4541 PROGRAMMABLE TIMER CMOS IC

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
UNISONIC TECHNOLOGIES CO., LTD CD4066 QUAD BILATERAL SWITCH „ DESCRIPTION The UTC CD4066 is a quad bilateral switch which can be applied for switching of analog signals and digital signals. When control input CONT is set to “H” level, the impedance between input and output of the switch becomes low and when it is set to “L” level, the impedance becomes high. It has a much lower “ON” resistance, and “ON” resistance is relatively constant over the input-signal range. „ FEATURES * 15V Digital or ±7.5V Peak-to-Peak Switching * 85-Ω Typical On-State Resistance for 15V Operation * High noise immunity 0.45 VDD (typ.) * Matched “ON” resistance ∆RON=5Ω (typ.) over 15V signal input * High degree linearity 0.1% distortion (typ.) @ fIS=1kHz, VIS=5VP-P, VDD-VSS=5V, RL=10kΩ * Extremely low “OFF” 0.