Datasheet4U Logo Datasheet4U.com

TPD1055FA - High side power switch

General Description

Power pin.

Input pin.

Input is connected to GND pin with pull down resistor.

Key Features

  • P-WSON10-0303-0.50-001.
  • A monolithic power IC with a structure combining a control Weight:0.02g(typ. ) block and a power MOSFET (D-MOS) on single chip.
  • One side of load can be grounded to a high-side switch.
  • AEC-Q100 qualified.
  • Can directly drive a power load from CMOS or TTL logic.
  • Built-in protection circuits against over temperature, over current.
  • Incorporates a diagnosis function that allows diagnosis output to be read externally at battery short,.

📥 Download Datasheet

Datasheet Details

Part number TPD1055FA
Manufacturer Toshiba
File Size 415.83 KB
Description High side power switch
Datasheet download datasheet TPD1055FA Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer

Other Datasheets by Toshiba

Part Number Description
TPD1052F Silicon Monolithic Power MOS
TPD1053F Silicon Monolithic Power MOS
TPD1054F Low-Side Switch
TPD1058FA Low-Side Switch
TPD1039F Low-Side Power Switch
TPD2015FN High-side switch
TPD2017FN Low-side switch
TPD4005K 3-Phase DC Brush Less Motor Driver
TPD4008K High Voltage Monolithic Silicon Power-IC
TPD4011K High Voltage Monolithic Silicon Power-IC

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
TPD1055FA Toshiba Intelligent Power Device Silicon Monolithic Power MOS Integrated Circuit TPD1055FA For Motor, Solenoid and Lamp High side power switch TPD1055FA is a High-side switch of a P channel DMOS output. It is monolithic power IC that can be driven directly from a CMOS or TTL logic circuit (MPU etc.), and was equipped with the intelligent function of protection and diagnosis. Features P-WSON10-0303-0.50-001  A monolithic power IC with a structure combining a control Weight:0.02g(typ.) block and a power MOSFET (D-MOS) on single chip.  One side of load can be grounded to a high-side switch.  AEC-Q100 qualified.  Can directly drive a power load from CMOS or TTL logic.  Built-in protection circuits against over temperature, over current.