P6SMB SERIES
Surface Mount Transient Voltage Suppressor
Voltage Range
6.8 to 200 Volts
600 Watts Peak Power
Features
SMB/DO-214AA
For surface mounted application in order to optimize board
space
Low profile package
Built-in strain relief
Glass passivated junction
Excellent clamping capability
www.DataSheet4U.comFast response time: Typically less than 1.0ps from 0 volt to
BV min.
Typical IR less than 1μA above 10V
High temperature soldering guaranteed:
250OC / 10 seconds at terminals
Plastic material used carries Underwriters Laboratory
Flammability Classification 94V-0
600 watts peak pulse power capability with a 10 x 1000 us
waveform by 0.01% duty cycle
Mechanical Data
Case: Molded plastic
Terminals: Solder plated
Polarity: Indicated by cathode band
Standard packaging: 12mm tape (EIA STD RS-481)
Weight: 0.093gram
.082(2.08)
.076(1.93)
.147(3.73)
.137(3.48)
.103(2.61)
.078(1.99)
.056(1.41)
.035(0.90)
.187(4.75)
.167(4.25)
.012(.31)
.006(.15)
.008(.20)
.004(.10)
.208(5.28)
.200(5.08)
.012(.31)
.006(.15)
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Rating at 25℃ambient temperature unless otherwise specified.
Type Number
Peak Power Dissipation at TA=25OC,
Tp=1ms(Note 1)
Peak Forward Surge Current, 8.3 ms Single Half
Sine-wave Superimposed on Rated Load
(JEDEC method) (Note 2, 3) - Unidirectional Only
Maximum Instantaneous Forward Voltage at
50.0A for Unidirectional Only (Note 4)
Operating and Storage Temperature Range
Symbol
PPK
IFSM
VF
TJ, TSTG
Value
Minimum 600
100
3.5
-65 to + 150
Units
Watts
Amps
Volts
OC
Notes: 1. Non-repetitive Current Pulse Per Fig. 3 and Derated above TA=25OC Per Fig. 2.
2. Mounted on 5.0mm2 (.013 mm Thick) Copper Pads to Each Terminal.
3. 8.3ms Single Half Sine-wave or Equivalent Square Wave, Duty Cycle=4 pulses Per Minute
Maximum.
Devices for Bipolar Applications
1. For Bidrectional Use C or CA Suffix for Types P6SMB6.8 through Types P6SMB200A.
2. Electrical Characteristics Apply in Both Directions.
- 620 -
