Datasheet4U Logo Datasheet4U.com

PGM2003-PP - (PGM20xx Series) CDS Photo Resistors

Download the PGM2003-PP datasheet PDF. This datasheet also covers the PGM5506 variant, as both devices belong to the same (pgm20xx series) cds photo resistors family and are provided as variant models within a single manufacturer datasheet.

Key Features

  • - Quick Response - Reliable Performance - Epoxy or hermetical package - Good Characteristic of Spectrum.

📥 Download Datasheet

Note: The manufacturer provides a single datasheet file (PGM5506_TOKEN.pdf) that lists specifications for multiple related part numbers.

Datasheet Details

Part number PGM2003-PP
Manufacturer TOKEN
File Size 401.52 KB
Description (PGM20xx Series) CDS Photo Resistors
Datasheet download datasheet PGM2003-PP Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
PGM08xxx-xx IC Socket / Pin Grid Array Aries Electronics
PGM12xxx-xx IC Socket / Pin Grid Array Aries Electronics

Other Datasheets by TOKEN

Part Number Description
PGM2003 (PGM20xx Series) CDS Photo Resistors
PGM2000 CDS Photo Resistors
PGM2000-PP (PGM20xx Series) CDS Photo Resistors
PGM2001 (PGM20xx Series) CDS Photo Resistors
PGM2001-PP (PGM20xx Series) CDS Photo Resistors

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
TOKEN PGM CDS Photoresistors CDS Light-Dependent Photoresistors Light-Dependent Photoresistors for Sensor Applications Preview The cadmium sulfide (CdS) or light dependent resistor (LDR) whose resistance is inversly dependent on the amount of light falling on it, is known by many names including the photo resistor, photoresistor, photoconductor, photoconductive cell, or simply the photocell. A typical structure for a photoresistor uses an active semiconductor layer that is deposited on an insulating substrate. The semiconductor is normally lightly doped to enable it to have the required level of conductivity. Contacts are then placed either side of the exposed area.