http://www.xiaoyu163.com
CDX-GT610U/GT616U/GT617UE
General
QQ 376315150 892498299Outputs
Audio outputs terminal (front/rear)
Notes on Chip Component Replacement
•N ever reuse a disconnected chip component.
Subwoofer output terminal (mono)
• Notice that the minus side of a tantalum capacitor may be damaged
Power antenna relay control terminal
Power amplifier control terminal
by heat.
Inputs
Telephone ATT control terminal
Illumination control terminal
BUS control input terminal
TEST DISCS
Please use the following test discs for the check on the CD section.
BUS audio input terminal/AUX IN terminal
Remote controller input terminal
YDES-18 (Part No. 3-702-101-01)
Tone controls
Antenna input terminal
Low: ±10 dB at 60 Hz (XPLOD)
PATD-012 (Part No. 4-225-203-01)
Mid: ±10 dB at 1 kHz (XPLOD)
Power requirements
Dimensions
High: ±10 dB at 10 kHz (XPLOD)
12 V DC car battery (negative ground)
Approx. 178 × 50 × 180 mm
CAUTION
Use of controls or adjustments or performance of procedures
(7 1/8 × 2 × 7 1/8 in.) (w/h/d)
other than those specif ied herein ma y result in hazardous
Mounting dimensions Approx. 182 × 53 × 162 mm
(7 1/4 × 2 1/8 × 6 1/2 in.) (w/h/d)
radiation exposure.
Mass
Approx. 1.3 kg (3 lb. 5 oz.)
Supplied accessories Card remote commander: RM-X151
Parts for installation and connections (1 set)
If the optical pic k-up block is defecti ve, please replace the whole
optical pick-up block.
Design and specifications are subject to change without
Never turn the semi-fixed resistor located at the side of optical pick-
notice.
up block.
US and foreign patents licensed from Dolby Laboratories.
optical pick-up
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential dif ference genera ted b y the
TEL 13942296513charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damag ed and should be handled with
care.
QQ 376315150 892498299
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, w hen c hecking the laser diode emission,
observe from more than 30 cm away from the objective lens.
semi-fixed resistor
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE P ARTS LIST ARE CRITICAL TO SAFE OPERA TION.
www . xiaoy u163.REPLACE THESE COMPONENTS WITH SONY P ARTS
WHOSE P ART NUMBERS APPEAR AS SHO WN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY .
com
2
http://www.xiaoyu163.com