Datasheet4U Logo Datasheet4U.com

AAT3103 - Three-Channel Charge-Pump LED Driver

General Description

The AAT3103 is a constant frequency charge-pump based current-source white LED driver capable of driving one to three LEDs up to 30mA, each.

The charge pumps automatically switch between 1x mode and 2x mode to maintain the highest efficiency and optimal LED current accuracy and matching.

Key Features

  • Source WLED Driver, up to 3 LEDs at up to 30mA, each.
  • Automatic Switching Between 1x and 2x Modes.
  • 900KHz Switching Frequency.
  • Linear LED Output Current Control.
  • Single-wire, S2Cwire Interface.
  • AAT3103-1: 16-step.
  • AAT3103-2: 8-step.
  • ON/OFF or PWM Interface.
  • AAT3103-4.
  • ±10% LED Output Current Accuracy.
  • ±3% LED Output Current Matching.
  • Low-current Shutdown Mode.
  • Built-in Short Circuit and Thermal Prot.

📥 Download Datasheet

Full PDF Text Transcription for AAT3103 (Reference)

Note: Below is a high-fidelity text extraction (approx. 800 characters) for AAT3103. For precise diagrams, and layout, please refer to the original PDF.

General Description The AAT3103 is a constant frequency charge-pump based current-source white LED driver capable of driving one to three LEDs up to 30mA, each. The charg...

View more extracted text
river capable of driving one to three LEDs up to 30mA, each. The charge pumps automatically switch between 1x mode and 2x mode to maintain the highest efficiency and optimal LED current accuracy and matching. A low external parts count (one 1μF flying capacitor, two small 1μF capacitors at IN and OUT and one current setting resistor) makes the AAT3103 ideally suited for small battery-powered applications. The AAT3103-1/-2 uses Skyworks' Simple Serial Control (S2Cwire™) interface to enable, disable, and program the LED driving current. The AAT3103-4 employs a Pulse Width Modulation (PWM) signal with up to 50kHz frequency, 1