LT1W67A Datasheet | Sharp Corporation

Full Color Leadless Chip LED Device LT1W67A(Under Development) s Outline Dimensions ±0.15 1616 Size, 0.8mm Thickness, pact Full Color Leadless Chip LED Device s Radiation Diagram (Ta=25˚C) (Unit : mm) 1.6 1.0 1.6±0.15 3 -20˚ -40˚ 0˚ 100 Relative luminous intensity(%) +20˚ +40˚ 80 60 40 20 +80˚ Red +60˚ Yellow-green -60˚ 1.2 0.5 1.0 0.3 Remended PWB pattern for soldering 0.3 -80˚ Soldering area -20˚ -40˚ (0.4) (0.6) 1.Plating area Resist 2.Pin connections 1 Anode(Yellow-green) 2 Anode(Red) 3 Anode(Blue) 4 Cathode(mon) 3.Unspecified tolerance:±0.2 0˚ 100 Relative luminous intensity(%) +20˚ +40˚ 80 60 40 20 Blue +60˚ -60˚ -80˚ +80˚ X Y s Absolute Maximum Ratings Power dissipation Forward current Peak forward current P- 1 IF IFM- 2 Model No. Radiation color Radiation material (m W) (m A) (m A) (Ta=25˚C) Derating factor Reverse voltage Operating temperature Storage temperature Soldering temperature (m A/˚C) VR Topr Tstg Tsol- 3 (V) (˚C) (˚C) (˚C) DC Pulse 260 260 260 Blue Ga N on Si C 200 30 100 0.67 1.33 5 -30 to +85 -40 to +100 LT1W67A Yellow-green Ga P 84 30 50 0.40 0.67 5 -30 to +85 -40 to +100 -30 to +85 -40 to +100 Red Ga As P on Ga P 84 30 50 0.40 0.67 5 - 1 The value is specified under the condition that either color is lightened separately. When all diodes are lightened simultaneously, the power dissipation of each diode should be less than 30% of the value specified in this table. - 2 Duty ratio=1/10, Pulse width=0.1ms - 3 For 3s or less at the temperature of hand soldering. Temperature of reflow soldering is shown on the below page. s Electro-optical Characteristics Radiation Lens Model No. color type Blue Milky LT1W67A Yellow-green diffusion Red Forward voltage VF(V) TYP 4.4 2.1 2.0 MAX 5.6 2.8 2.8 Peak emission wavelength IF λp(nm) (m A) TYP 430 20 565 20 635 20 Luminous intensity IF IV(mcd) (m A) TYP 6.5 20 13.0 20 8.5 20 Spectrum radiation bandwidth IF ∆λ(nm) (m A) TYP 70 20 30 20 35 20 Reverse current VR...