TS13101 Datasheet | SEMTECH

Features - Low Quiescent Operating Currents ŒŒ 2u A in OFF state ŒŒ 4u A in ON state - Scalable galvanic isolation from primary to secondary sides of the device - Single control signal for on/off input (CLK) ŒŒ Operation from 2.9V to 5.5V patible with standard microcontrollers - Switch Characteristics ŒŒ High voltage switch with bi-directional blocking in OFF state ŒŒ Single switch device ŒŒ 60V switch and 110mohm Rdson ŒŒ Up to 4A operating current Specification - Junction operating temperature -40 °C to 125 °C - Packaged in a 20pin QFN (4x4) Description The TS13101 is a galvanically isolated 60V power switch device with bi-directional blocking. The device includes a single integrated 110m Ohm high voltage FET allowing high efficiency switching of power loads or other high current applications. The input pin, CLK, controls the turn on/off of the switch. When the correct CLK sequence is provided the switch will latch on and stay on until the turn off sequence is given or a fault is detected. The TS13101 includes several protection features . Each FET has an integrated over-current shut-down to prevent device damage during short-circuit or other unusually high load conditions. If an over-current event is detected for a time the FET is latched off until the CLK turn off sequence is given. While the CLK pin is active after an over-current event or in the event of an incorrect turn-on sequence, the DATA pin is toggled at ¼ the CLK frequency. Applications - Power load/rail switching - Input supply muxing - Isolated power supplies - Solid state relays - HVAC control Typical Application Circuit VCC GPIO1 GPIO2 u C TS13101 Final Datasheet October 22, 2015 Rev 1.0 Ccp Load VDD1 CPP CISO CLK Cdata DATA C1 VDD2 C2 SYSP SW1 Csys SW2 SUB Csub .semtech. SYSM 1 of 10...