L6360 Datasheet | STMicroelectronics

Features - Supply voltage from 18 V to 32.5 V - Programmable output stages: high-side, low-side or push-pull (< 2 Ω) - Up to 500 m A L+ protected high-side driver - 1, 2 and 3 mode supported - Additional IEC61131-2 type 1 input - Short-circuit and overcurrent output protection through current limitation and programmable cut-off current - 3.3 V / 5 V, 50 m A linear regulator - 5 m A IO-Link digital input - Fast mode I2C for IC control, configuration and diagnostic - Diagnostic dual LED sequence generator and driver - 5 V and 3.3 V patible I/Os - Overvoltage protection (> 36 V) - Overtemperature protection - ESD protection - Miniaturized VFQFPN 26L (3.5x5x1 mm) package Applications - Industrial sensors - Factory automation - Process control Description The L6360 is a monolithic IO-Link master port pliant with PHY2 (3-wire) supporting 1 (4.8 kbaud), 2 (38.4 kbaud) and 3 (230.4 kbaud) modes. The C/QO output stage is programmable: high-side, low-side or push-pull; also cut-off current, cut-off current delay time, and restart delay are programmable. Cut-off current and cut-off current delay time, bined with thermal shutdown and automatic restart, protect the device against overload and short-circuit. C/QO and L+ output stages are able to drive resistive, inductive and capacitive loads. Inductive loads up to 10 m J can be driven. Supply voltage is monitored and low voltage conditions are detected. The L6360 transfers, through the PHY2(C/QO pin), data received from a host microcontroller through the USART (IN C/QO pin), or to the USART (OUT C/QI pin) data received from PHY2 (C/QI pin). To enable full IC control, configuration and monitoring (i.e. fault conditions stored in the status register), the munication between the system microcontroller and the L6360 is based on a fast mode 2-wire I2C. The L6360 has nine registers to manage the programmable parameters and the status of the IC. Monitored fault conditions are: L+ line, overtemperature, C/Q overload, linear regulator...