Surface Mount Transient Voltage Suppressors (TVS)
P6SMB Series 6.8 To 600 V 600W
The P6SMB series is designed specifically to protect sensitive electronic
equipment from voltage transients induced by lightning and other transient
u For surface mounted applications in order to optimize board space
u Low leakage
u Uni and Bidirectional unit
u Glass passivated junction
u Low inductance
u Excellent clamping capability
u 600W Peak power capability at 10 × 1000µs waveform Repetition rate
u Fast response time: typically less than 1.0ps from 0 Volts to VBR min
u Typical IR less than 5μA above 12V.
u High Temperature soldering: 260°C/40 seconds at terminals
u Typical maximum temperature coefficient ΔVBR = 0.1% ×
u Plastic package has Underwriters Laboratory Flammability 94V-0
u Matte tin lead–free Plated
u Halogen free and RoHS compliant
u Typical failure mode is short from over-specified voltage or current
u Whisker test is conducted based on JEDEC JESD201A per its table
4a and 4c
u IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact)
u ESD protection of data lines in accordance with IEC 61000-4-2
u EFT protection of data lines in accordance with IEC 61000-4-4
Maximum Ratings (TA=25℃ unless otherwise noted)
AGENCY FILE NUMBER
TVS devices are ideal for the protection of I/O interfaces, VCC
bus and other vulnerable circuits used in Telecom, Computer,
Industrial and Consumer electronic applications.
Peak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note
1), (Note 2)
Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3)
Power Dissipation on Infinite Heat Sink at TL=75°C
Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3)
Maximum Instantaneous Forward Voltage at 25A for Unidirectional Only
Operating junction and Storage Temperature Range.
TJ , TSTG
1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25°C per Fig. 2.
2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.
4. VF < 3.5V for VBR < 200V and VF< 6.5V for VBR > 201V.
See Next Table
-55 to +150
SOCAY Electronics Co., Ltd.
Revision September 25, 2013
@ SOCAY Electronics Co., Ltd. 2013
Specifications are subject to change without notice.
Please refer to www.socay.com for current information.