Datasheet4U Logo Datasheet4U.com

MK5811A - LOW EMI CLOCK GENERATOR

Description

The MK5811A device generates a low EMI output clock from a clock or crystal input.

The device is designed to dither a high emissions clock to lower EMI in consumer applications.

Features

  • Packaged in 8-pin SOIC.
  • Pb (lead) free package.
  • Provides a spread spectrum output clock.
  • Supports flat panel controllers.
  • Accepts a clock or crystal input (provides same frequency dithered output).
  • Input frequency range of 4 to 32 MHz.
  • Output frequency range of 4 to 32 MHz.
  • 1X frequency multiplication.
  • Center and down spread.
  • Peak reduction by 8 dB to 16 dB typical on 3rd through 19th odd harmonics.

📥 Download Datasheet

📁 Similar Datasheet

  • MK5002 - Magnetic Cylinder Switches (ETC)
  • MK5009 - Counter Time Base Circuit (Mostek)
  • MK5014 - Magbetic Cylinder Switches (IFM)
  • MK50240 - Top-Octave Frequency Generator (MOSTEK)
  • MK50241 - Top-Octave Frequency Generator (MOSTEK)
  • MK50242 - Top-Octave Frequency Generator (MOSTEK)
  • MK50242N - Top-Octave Frequency Generator (MOSTEK)
  • MK50242P - Top-Octave Frequency Generator (MOSTEK)
  • MK5025 - CCITT X.25 Link Level Controller (ST Microelectronics)
  • MK50250 - MOS Digital Alarm Clock (MOSTEK)
Other Datasheets by Renesas

    Full PDF Text Transcription

    Click to expand full text
    LOW EMI CLOCK GENERATOR DATASHEET MK5811A Description The MK5811A device generates a low EMI output clock from a clock or crystal input. The device is designed to dither a high emissions clock to lower EMI in consumer applications. Using IDT’s proprietary mix of analog and digital Phase Locked Loop (PLL) technology, the device spreads the frequency spectrum of the output and reduces the frequency amplitude peaks by several dB. The MK5811A offers both centered and down spread from a high-speed clock input. For different multiplier configurations, use the MK5812 (2x) or MK5814 (4x). IDT offers many other clocks for computers and computer peripherals. Consult IDT when you need to remove crystals and oscillators from your board.
    Published: |