Datasheet4U Logo Datasheet4U.com

PT4305 - 1x/1.5x Auto-Adjust Charge Pump

Key Features

  • PT4305 is a 1x/1.5x auto-adjust charge pump white z 1x/1.5x auto-adjust charge pump LED driver with maximum 350mA load. Auto-adjust z 350mA maximum load current charge pump achieves high efficiency for Li-Ion battery z.

📥 Download Datasheet

Datasheet Details

Part number PT4305
Manufacturer PowTech
File Size 668.08 KB
Description 1x/1.5x Auto-Adjust Charge Pump
Datasheet download datasheet PT4305 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
PT4305 315 MHz / 433.92 MHz PLL Tuned Low Power FSK Receiver PTC
PT430 Narrow Acceptance Phototransistor Sharp Electrionic
PT4301 Low Power High Sensitivity 315/434 MHz OOK/ASK Superheterodyne Receiver PTC
PT4301 1x/1.5x Auto-Adjust Charge Pump 4-Channel White LED Driver ETC
PT4302 Ultra-Low Power OOK/ASK Receiver PTC

Other Datasheets by PowTech

Part Number Description
PT4301 4 Channel 1x/1.5x Auto-Adjust Charge Pump White LED Driver
PT4302 2 Channel 1x/1.5x Auto-Adjust Charge Pump White LED Driver
PT4303 1x/1.5x Auto-Adjust Charge Pump 4-Channel White LED Driver
PT4101 White LED Step-Up Converter
PT4103 White LED Step-Up Converter

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
PT4305 1x/1.5x Auto-Adjust Charge Pump One Channel White LED Driver for Flash GENERAL DESCRIPTION FEATURES PT4305 is a 1x/1.5x auto-adjust charge pump white z 1x/1.5x auto-adjust charge pump LED driver with maximum 350mA load. Auto-adjust z 350mA maximum load current charge pump achieves high efficiency for Li-Ion battery z <10% feedback voltage reference error Micro Bridge Technology Co.,Ltd. supply. Few external components (two flying capacitors, two filter capacitors at VIN and VOUT, and one feedback resistor) make PT4305 ideally suited for mobility application. The current through the LED can be pre-set by feedback resistor. And the LED can also be dimmed by PWM control signal. Built-in soft-start circuit prevents the inrush current from supply source during power on and 1x/1.