PVM5xxx Datasheet | Pletronics

Pl tronics., Inc. 19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA Manufacturer of High Quality Frequency Control Products PVB, PVM PECL VCXO Series Differential PECL Output with Enable/Disable 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator Standard Specifications Overall Frequency Stability Operating Temperature Range Storage Temperature Range Supply Voltage (Vcc) Supply Current (Icc) Output High Level ± 50 PPM, ± 25 PPM, ± 20 PPM over Operating Temperature Range 0 to +70°C is standard, but can be extended to - 40 to +85°C - 55 to +125°C 3.3 volts ± 5% standard, but 5.0 volts or 2.5 volts also available. See Test Cirucit 5. < 250 MHz = 90 m A maximum, 250 MHz and above = 100 m A maximum 2.275 V minimum referenced to Ground, Vcc = 3.300V, 0.975 V minimum referenced to termination voltage, - 1.025 V minimum referenced to Vcc 1.680 V maximum referenced to Ground, Vcc = 3.300V, 0.380 V maximum referenced to termination voltage, - 1.620 V maximum referenced to Vcc 45/55% referenced to 50% of amplitude 1.0 n S maximum when Vth is 10% and 90% of waveform 6 p S RMS maximum measured from 12 k Hz to 20 MHz from output frequency 50 kohm minimum to Vcc 0.3 Vcc maximum referenced to Ground 0.7 Vcc minumum referenced to Ground ± 10% typical Positive and montonic For 5.0 Vcc, CVR = 0.5 to 4.5 V, For 3.3 Vcc, CVR = 0.0 to 3.3 V, For 2.5 Vcc, CVR = 0.0 to 2.5 V Pull range is defined as absolute pull range. This is the pull range about the specified oscillator frequency, independent of supply, temperature range and load. Typical values are ± 25, ± 50 and ± 100 PPM. 100 n S maximum 100 n S maximum Q Output = Logic Low, QN Output = Logic High. Both Outputs are active Part Numbering Guide Portions of the part number that appear after the frequency may not be marked on part (C of C provided) Packaging PVM = Tube PVB = Tube or 24mm tape 16mm pitch PVB 5 V B V - 100.0M - XXX (Internal Code or blank) 1.00 MHz - 650.00 MHz Consult factory for higher...