PI4MSD5V9545A Datasheet | Pericom Semiconductor

Features - 1-of-4 bidirectional translating multiplexer - I2C-bus interface logic - Operating power supply voltage :1.65 V to 5.5 V - Allows voltage level translation between 1.2V, Description The PI4MSD5V9545A is a quad 1-of-4 bidirectional translating switch, controlled via the I2C bus. The SCL/SDA upstream pair fans out to four SCx/SDx downstream pairs, or channels. 1.8V,2.5 V, 3.3 V and 5 V buses - Low standby current - Low Ron switches - Channel selection via I2C bus - Power-up with all multiplexer channels deselected - Capacitance isolation when channel disabled - No glitch on power-up - Supports hot insertion - 5 V tolerant inputs - 0 Hz to 400 k Hz clock frequency - ESD protection exceeds 8000 V HBM per JESD22- Any individual SCx/SDx channel or bination of channels can be selected, determined by the contents of the programmable control register. Four interrupt inputs, INT0 to INT3, one for each of the downstream pairs, are provided. One interrupt output, INT, acts as an AND of the four interrupt inputs. An active LOW reset input allows the PI4MSD5V9545A to recover from a situation where one of the downstream buses is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C bus state machine and causes all the channels to be deselected as does the A114, and 1000 V CDM per JESD22-C101 - Latch-up testing is done to JEDEC Standard internal power-on reset function. The pass gates of the switches are constructed such JESD78 which exceeds 100 m A - Packages offered: TSSOP-20L that the VCC pin can be used to limit the maximum high voltage which will be passed by the PI4MSD5V9545A. This allows the use of different bus voltages on each pair, so that 1.2V,1.8 V or 2.5 V or 3.3 V parts can municate with 5 V parts without any additional protection. External pull-up resistors pull the bus up to the desired voltage level for each channel. All I/O pins Pin Configuration are 5 V tolerant. TSSOP20 2015-07-0036 PT0526-4 8/18/15 1 PI4MSD5V9545A 4 Channel I2C...